Oregon Scientific BAR888RA Clock, Data Transmission, Search for Sensor, Icon Description

DATA TRANSMISSION

Data is sent from the sensor(s) every 40 seconds. The reception icon shown in the Temperature Area shows the status.

ICON	DESCRIPTION
	Main unit is searching for
	sensors.
	At least 1 Channel has been
	found.
	Channel 1 is selected
	(number will change
	depending on the sensor
	you select).
--- shows in Outdoor	The selected sensor cannot
Temp Area	be found. Search for the
	sensor or check batteries.

		EN
SEARCH FOR SENSOR
To search for a sensor, press and hold MEMORY and
CHANNEL for 2 seconds.
NOTE	If the sensor is still not found, check the
batteries, obstructions, and remote unit loaction.
NOTE	Signals from household devices such as
doorbells, electronic garage doors, and home security
systems may cause temporary reception failure. This is
normal and does not affect general product performance.
The reception will resume once the interference ends.

CLOCK

The main unit automatically synchronizes the current time and date on the clock when it is brought within range of the WWVB-60 atomic clock signal generated from Fort Collins, Colorado. For more information, please visit: www.boulder.nist.gov/timefreq.stations/radioclocks.htm. The signals are collected by the main unit when it is within 932 miles (1500 km) of a signal.

Initial reception takes 2-10 minutes, and is initiated when you first setup the unit, and whenever you press RESET. Once complete, the reception icon will stop blinking. The icon is shown in the Clock Area.

7

BAR888RA_EN_R15 7 4/12/05, 9:43 AM