Oregon Scientific BAR888RA user manual Remote Sensor THN122N, Setup Sensor, Switch Option

EN
	REMOTE SENSOR (THN122N)
	This product is shipped with two THN122N Thermometer
	Sensors that collect temperature data. Data can be collected
	from up to 3 sensors. Additional sensors sold separately.

SETUP SENSOR

1.Open the remote sensor battery compartment with a small Phillips screwdriver.

2.Insert the batteries, matching the polarity (+ and –) as shown in the battery compartment.

SWITCH		OPTION
Channel		Channel 1-3. If you are using more than
		one sensor, select a different channel
		for each sensor.
3.	Set the channel. The switch is located in the battery
	compartment.
4.	Place the sensor near the main unit. Press RESET on
	the sensor. Then, press and hold MEMORY and
	CHANNEL on the main unit to initiate signal sending
	between the sensor and the main unit. The reception
	icon on the main unit will blink for approximately 3
	minutes while it is searching for the sensor. (Refer to
	the “Data Transmission” section for more information.)
5.	Close the remote sensor battery compartment.
6.	Secure the sensor in the desired location using the
	wall mount or table stand.
		6

Installing the batteries:

For best results:

•Insert the batteries and select the channel before you mount the sensor.

•Place the sensor out of direct sunlight and moisture.

•Do not place the sensor more than 230 feet (70 meters) from the main (indoor) unit.

•Position the sensor so that it faces the main (indoor) unit, minimizing obstructions such as doors, walls, and furniture.

•Place the sensor in a location with a clear view to the sky, away from metallic or electronic objects.

•Position the sensor close to the main unit during cold winter months as below-freezing temperatures may affect battery performance and signal transmission.

You may need to experiment with various locations to get the best results.

BAR888RA_EN_R15 6 4/12/05, 9:43 AM