Optoma Technology 1080p DLP manual Powering On/Off the Projector, Powering On the Projector

Page 13

Installation

Powering On/Off the Projector

Powering On the Projector

1.Remove the lens cap. 

2.Ensure that the power cord and signal cable are securely connected. The Power LED will turn red.

3.Turn on the lamp by pressing “ ” button on the control panel. And the Power LED will turn blue.

The startup screen will display in approximately 30 seconds. The ﬁrst time you use the projector, you can select your preferred language from quick menu after the startup screen display.

English

4.Turn on your source (computer, notebook, video player, etc.). The projector will detect your source automatically within “Setup” menu, check that “Source Lock” has been set to “Off”.

▀■If you connected multiple sources at the same time, press the “Source” button on the control panel or direct source key on the remote control to switch between inputs.

Note

Turn on the projector ﬁrst and then select the signal sources.

1

2

13

Image 13

Contents Table of contents Important Safety Instruction Safety InformationClass B emissions limits Precautions Do not Usage Notice Eye Safety WarningsIntroduction Product FeaturesEnglish Package OverviewMain Unit Product OverviewEnglish Control PanelConnection Ports Remote Control Connecting the Projector InstallationPowering On the Projector Powering On/Off the ProjectorPowering Off the Projector Adjusting the Projector’s Height Adjusting the Projected ImageAdjusting Projection Image Size Adjusting the Projector’s Zoom / FocusControl Panel & Remote Control Contrast BrightnessImage AI GammaNative 169Letter-Box YPbPrOn-screen Display Menus How to operateMenu Tree SetupMode ImageTint Gamma Noise ReductionDegamma Edge EnhanceColor Temp Format DisplayEdge Mask OverscanImage Shift Keystone Input Source LanguageSource Lock Signal Auto Power OffHigh Altitude Reset Projection Menu LocationImage AI Background Test Pattern12V Trigger Lamp Reset Brite ModeLamp Hour Lamp ReminderImage Problems TroubleshootingNo image appears on-screen Partial, scrolling or incorrectly displayed imageImage has vertical ﬂickering bar Unstable or ﬂickering imageIntermission Problems Lamp burns out or makes a popping sound Projector Status IndicationLED states Message RemindersIf the remote control does not work Remote Control ProblemsReplacing the lamp Lamp Replacing ProcedureCompatibility Modes Mode Resolution Frequency AAnalog DigitalRS232 Pin Assignments RS232 Commands and Protocol Function ListRS232 Protocol Function List Comand Header Blank Address Code Command Terminator Et/ g et Ceiling Mount Installation USA Optoma Global OfﬁcesChina Regulation & safety notices Remarque à l’intention des utilisateurs cana- diens