Optoma Technology 1080p DLP manual Intermission Problems

Page 38

Appendices

Image is out of focus

Make sure the Lens cap is removed.

Adjusts the Focus Ring on the projector lens.

Make sure the projection screen is between the required dis- tance 4.9 to 39.4 feet (1.5 to 12.0 meters) from the projector. See page 16.

The image is stretched when displaying 16:9 DVD title

When you play anamorphic DVD or 16:9 DVD, the projector will show the best image in 16: 9 format on projector side.

If you play the LBX format DVD title, please change the format as LBX in projector OSD.

If you play 4:3 format DVD title, please change the format as 4:3 in projector OSD.

If the image is still stretched, you will also need to adjust the aspect ratio by referring to the following:

Please setup the display format as 16:9 (wide) aspect ratio type on your DVD player.

Image is too small or too large

Adjust the zoom lever on the top of the projector.

Move the projector closer to or further from the screen.

Press [ 4:3], [ 16:9], [ Letter-Box], [ Native] button on the remote control or [Menu] on the projector panel, go to “Display-->Format”. Try the different settings.

Image has slanted sides:

If possible, reposition the projector so that it is centered on the screen and below the bottom of the screen.

Usement.“Display-->V.Keystone” from the OSD to make an adjust-

Image is reversed

Select “System-->Projection” from the OSD and adjust the pro- jection direction.

Intermission Problems

The projector stops responding to all controls

If possible, turn off the projector, then unplug the power cord and wait at least 20 seconds before reconnecting power.

38

Image 38
Contents Table of contents Class B emissions limits Safety InformationImportant Safety Instruction Precautions Do not Eye Safety Warnings Usage NoticeProduct Features IntroductionPackage Overview EnglishProduct Overview Main UnitControl Panel EnglishConnection Ports Remote Control Installation Connecting the ProjectorPowering On/Off the Projector Powering On the ProjectorPowering Off the Projector Adjusting the Projected Image Adjusting the Projector’s HeightAdjusting the Projector’s Zoom / Focus Adjusting Projection Image SizeControl Panel & Remote Control Image AI BrightnessContrast GammaLetter-Box 169Native YPbPrHow to operate On-screen Display MenusSetup Menu TreeImage ModeTint Degamma Noise ReductionGamma Edge EnhanceColor Temp Display FormatImage Shift OverscanEdge Mask Keystone Source Lock LanguageInput Source High Altitude Auto Power OffSignal Reset Image AI Menu LocationProjection Test Pattern Background12V Trigger Lamp Hour Brite ModeLamp Reset Lamp ReminderNo image appears on-screen TroubleshootingImage Problems Partial, scrolling or incorrectly displayed imageUnstable or flickering image Image has vertical flickering barIntermission Problems LED states Projector Status IndicationLamp burns out or makes a popping sound Message RemindersRemote Control Problems If the remote control does not workLamp Replacing Procedure Replacing the lampMode Resolution Frequency AAnalog Digital Compatibility ModesRS232 Commands and Protocol Function List RS232 Pin AssignmentsRS232 Protocol Function List Comand Header Blank Address Code Command Terminator Et/ g et Ceiling Mount Installation Optoma Global Offices USAChina Regulation & safety notices Remarque à l’intention des utilisateurs cana- diens