Optoma Technology EP 610 (H) specifications Changing the lamp, Lamp Changing Procedure

Page 22

22

English

wChanging the lamp

The projection display will detect the lamp life itself. It will show you a warning message when the lamp is used over working hours. When you see this message, change the lamp as soon as possible.

Make sure the projection display has been cooled for at least 60 minutes before changing the lamp.

!Warning: Lamp compartment is hot! Allow it to cool before changing lamps!

4Lamp Changing Procedure:

1.Turn off the power and allow the projection display to cool down.

2.Disconnect the power cord.

3.Unscrew the 2 screws of the lamp cover and remove the cover.

Lamp Cover

Lamp Cover

Screws

Image 22

Contents Table of Contents Precautions Usage NoticeIntroduction About the ProductPackage Overview Product Overview InstallationMain Unit Connection Ports Panel ControlsRemote Control Connecting the Projection Display Powering On the Projection Display Powering On/Off the Projection DisplayPowering Off the Projection Display Adjusting the image size Adjust the height of projected imageAdjusting the Image Size Focus the imageUser Controls Panel Control Remote ControlUser Control Overview Tracking Computer mode only Power/StandbyVolume Zoom In Computer mode onlyHow to operate OSD MenusImage Computer mode only Projection Lamp Problem Partial, scrolling or incorrectly displayed image Problem No image appears on screenAppendices Problem Image has vertical flickering bar Problem Image is unstable or flickering Problem Image is out of focus Problem The screen is outstretched when displaying 169 DVD Cleaning the Air Filter Maintenance4Cleaning Procedure Lamp Changing Procedure Changing the lampLamp Handle Lamp Screws Specifications XGAMode Resolution Frequency KHz Compatibility Modes