Optoma Technology EP 610 (H) specifications Powering On/Off the Projection Display

Page 9

English

9

Powering On/Off the Projection Display

uPowering On the Projection Display.

1.Remove the lens cover

2.Plug the power cord into the back of the projector and plug it into the electrical outlet. The “POWER/STANDBY” LED indicator will flash green.

3.Turn on the lamp by pressing “ POWER/STANDBY” button.

The startup screen displays and starts 30 seconds countdown for lamp . The “POWER/STANDBY” LED indicator will lit green and stop flashing. The “LAMP” LED indicator will flash amber for 30 seconds.

4.Make sure the computer or video signal is well connected. The projector will detect your computer source automatically.

5.If necessary, make adjustments to the image from the projector’s On-Screen Display (OSD)menus.

uPowering Off the Projection Display.

Turn off the lamp by pressing “ POWER/STANDBY” button. The confirmation message, ”Power off the lamp? ” will show up. Please select “Yes” to turn off the lamp. “LAMP” LED indicator will flash amber for about one minute. After the “LAMP” LED indicator stops flashing, you may unplug the power cord.

Warning:

*When the “LAMP” LED indicator lit amber for a long period of time, please change the lamp module. Please contact your local dealer or distributor for replacement lamp and refer to “ Changing the lamp”(Page 21) in the manual.

*When the “TEMP” LED indicator lit amber, it indicates the display has been overheated. The display will automatically shut itself down. While the “TEMP” LED indicator turns “off”, the display can be switched on again for your presentation.

Image 9
Contents Table of Contents Usage Notice PrecautionsAbout the Product IntroductionPackage Overview Installation Product OverviewMain Unit Panel Controls Connection PortsRemote Control Connecting the Projection Display Powering On/Off the Projection Display Powering On the Projection DisplayPowering Off the Projection Display Adjust the height of projected image Adjusting the image sizeFocus the image Adjusting the Image SizePanel Control Remote Control User ControlsUser Control Overview Volume Power/StandbyTracking Computer mode only Zoom In Computer mode onlyOSD Menus How to operateImage Computer mode only Projection Lamp Problem No image appears on screen Problem Partial, scrolling or incorrectly displayed imageAppendices Problem Image is unstable or flickering Problem Image has vertical flickering barProblem Image is out of focus Problem The screen is outstretched when displaying 169 DVD Maintenance Cleaning the Air Filter4Cleaning Procedure Changing the lamp Lamp Changing ProcedureLamp Handle Lamp Screws XGA SpecificationsCompatibility Modes Mode Resolution Frequency KHz