Optoma Technology EP 610 (H) specifications Lamp Handle Lamp Screws

Page 23

English

23

4.Unscrew the 2 screws of the lamp module and pull out the lamp module by the handle.

Lamp Handle

Lamp Screws

5. Replace the new lamp module by the handle and tighten the screws.

Lamp Handle

6.Place the lamp cover back in position and lock the 2 screws.

7.Remember to reset the lamp life timer from OSD menus.

Image 23

Contents Table of Contents Usage Notice PrecautionsAbout the Product IntroductionPackage Overview Main Unit InstallationProduct Overview Panel Controls Connection PortsRemote Control Connecting the Projection Display Powering Off the Projection Display Powering On/Off the Projection DisplayPowering On the Projection Display Adjust the height of projected image Adjusting the image sizeFocus the image Adjusting the Image SizeUser Control Overview Panel Control Remote ControlUser Controls Zoom In Computer mode only Power/StandbyVolume Tracking Computer mode onlyOSD Menus How to operateImage Computer mode only Projection Lamp Appendices Problem No image appears on screenProblem Partial, scrolling or incorrectly displayed image Problem Image is out of focus Problem Image is unstable or flickeringProblem Image has vertical flickering bar Problem The screen is outstretched when displaying 169 DVD 4Cleaning Procedure MaintenanceCleaning the Air Filter Changing the lamp Lamp Changing ProcedureLamp Handle Lamp Screws XGA SpecificationsCompatibility Modes Mode Resolution Frequency KHz