InFocus DP9295 manual Troubleshooting

Page 40

APPENDIX

TROUBLESHOOTING

Before calling your dealer or service center for assistance, check matters below once again.

1.Make sure you have connected a projector to your computer or video equipment as described in section "CONNECTING PROJECTOR" on pages 11 ~ 13.

2.Check cable connection. Verify that all computer, video and power cord are properly connected.

3.Verify that all power is switched on.

4.If a projector still does not produce an image, re-start your computer.

5.If an image still does not appear, unplug a projector from your computer and check your computer monitor's display. Problem may be with your graphics controller rather than with a projector. (When you reconnect a projector, be sure to turn computer and monitor off before you power up a projector. Power equipment back on in order of : Projector and computer.)

6.If problem still exists, check following chart.

E

 

 

 

Problem:

Try these Solutions

 

 

 

 

No power.

● Plug a projector into your AC outlet.

 

 

 

● Make sure READY Indicator lights.

 

 

 

● Wait 90 seconds after a projector is turned OFF when turning a projector back on.

 

 

 

NOTE : After pressing Power ON-OFF button to OFF, make sure a projector works as

 

 

 

follows:

 

 

 

1. LAMP indicator lights bright and READY indicator turns off.

 

 

 

2. After 90 seconds, READY indicator lights green again and a projector may be

 

 

 

turned on by pressing Power ON-OFF button.

 

 

 

● Check WARNING TEMP. indicator. If indicator flashes red, a projector cannot be turned

 

 

 

on.

 

 

 

(See "TURNING ON/OFF PROJECTOR" section on page 19.)

 

 

 

● Check Projection Lamp. (Refer to page 39.)

 

 

 

 

 

 

Image is out of

● Adjust focus of a projector.

 

 

focus.

● Make sure a projection screen is at least 4.6’ (1.4m) from a projector.

 

 

● Check Projection Lens to see if it needs cleaning.

 

 

 

 

 

 

NOTE : Moving a projector from a cool temperature location to a warm temperature location

 

 

 

may result in moisture condensation on Projection Lens. In such an event, leave a

 

 

 

projector OFF and wait until condensation disappears.

 

 

 

 

 

 

Picture is Left/Right

● Check Ceiling / Rear feature. (See “SETTING” section on page 35.)

 

 

reversed.

 

 

 

 

 

 

 

Picture is

● Check Ceiling feature. (See “SETTING” section on page 35.)

 

 

Top/Bottom

 

 

 

reversed.

 

 

 

 

 

 

 

Some displays are

● Check Display feature.(See “SETTING” section on page 35.)

 

 

not seen during

 

 

 

Operation.

 

 

 

 

 

 

 

No image.

● Check connection between your computer or video equipment and a projector.

 

 

 

● When turning a projector on, it takes about 30 seconds to display an image.

 

 

 

● Check system that you select is corresponding with your computer or video equipment.

 

 

 

● Make sure temperature is not out of Operating Temperature (5°C ~ 35°C).

 

 

No sound.

● Check audio cable connection from audio input source.

 

 

 

● Adjust audio source.

 

 

 

● Press VOLUME (+) button.

 

 

 

● Press MUTE button.

 

 

 

 

40

Page 39 Page 41
Image 40
Page 39 Page 41
Contents DP9295 To the Owner Safety Instructions Voor de klanten in NederlandCompliances Federal Communication Commission NoticeTable of Contents Features and Design ComputersColor Systems Component VideoPreparation Name of Each Part of ProjectorSETTING-UP Projector Connecting AC Power CordFor U.S.A. and Canada For Continental Europe 200 240 V ACPreparation Positioning Projector Room LightPreparation Adjustable Feet Moving ProjectorConnecting Projector USB Connector Series BTerminals of Projector BNC Input JacksConnecting to Computer Terminals A ProjectorConnecting to Video Equipment Before Operation Operation of Remote ControlLaser Pointer Function Volume Button Wired Remote JackZoom Button Focus ButtonTOP Controls and Indicators Point Volume + / ButtonsOperating ON-SCREEN Menu HOW to Operate ON-SCREEN MenuFlow of ON-SCREEN Menu Operation Guide Window Before Operation Menu BARSound Menu Turning on Projector Turning on / OFF ProjectorTurning OFF Projector Keystone Adjustment Adjusting ScreenBasic Operation Sound Adjustment Computer Input Selecting Input SourceSelecting Computer System Input MenuPC Adjustment Auto PC AdjustmentComputer Input Automatic MULTI-SCAN System AutoComputer Input Manual PC Adjustment Computer Input Display areaDisplay area H Full screenComputer Input Compatible Computer Specifications Resolution640 x 31.469 59.940 1024 x 48.363 60.004Picture Image Adjustments Image Level Select DirectImage Level Select Menu Image 1~4Computer Input Image Level Adjustment Image Adjust MenuPicture Screen Adjustment Screen MenuVideo Input VideoPb/Cb,Pr/Cr Source Select Menu VideoComponent Video Signal Format Selecting Video SystemVideo Input PAL / Secam / Ntsc / NTSC4.43 / PAL-M / PAL-NCinema Image button Standard CinemaVideo Input Image Level Adjustment Reset Reset all adjustment to previous figure Quit Closes Image MenuSetting Menu SettingSetting Menu To change code of Remote Control Unit Wireless Mouse modeProjector mode To change code of ProjectorSETTING/APPENDIX Operating Wireless MouseInstallation Operating Wireless MouseAIR Filter Care and Cleaning MaintenanceCleaning Projection Lens Appendix Lamp Replacement Lamp Replace CounterTroubleshooting Remote Control Unit Wireless MouseDoes not work Function does notTechnical Specifications Appendix Configurations of Terminals USB Connector Series BWarranty Limitation and Exclusion Limitation of Liability 11/2002 610 304 0028 1AA6P1P3747-- MK3F

DP9295 specifications

The InFocus DP9295 is a state-of-the-art digital projector designed for a wide range of applications, including corporate presentations, educational environments, and large-scale events. This projector stands out due to its impressive combination of advanced features, robust technology, and user-friendly characteristics.

One of the main highlights of the DP9295 is its high-resolution capability. Boasting a native resolution of 1920x1080 pixels, it delivers stunningly clear images with rich detail and vibrant colors. This level of clarity is essential for presentations that include intricate graphics or high-definition videos, ensuring that every element is visible even in large venues.

The DP9295 employs advanced DLP (Digital Light Processing) technology, which enhances image quality through improved color accuracy and consistency. DLP is known for its reliability and longevity, making the InFocus DP9295 a dependable choice for long-term use. Furthermore, the projector features a brightness rating of 5000 ANSI lumens, allowing it to perform well even in well-lit environments. This high brightness ensures that images remain sharp and legible, providing a captivating viewing experience.

In addition to its impressive imaging capabilities, the InFocus DP9295 offers a versatile range of connectivity options. It includes HDMI, VGA, and USB ports, facilitating seamless connections to various devices such as laptops, desktops, and media players. This flexibility is crucial in today’s diverse tech landscape, where users often require compatibility with multiple devices.

Another noteworthy characteristic is the projector's robust sound system. Equipped with built-in speakers, the DP9295 delivers impressive audio quality that complements its high-definition visuals. This is particularly advantageous for presentations and multimedia displays, reducing the need for additional sound equipment.

The InFocus DP9295 also prioritizes user convenience, featuring a simple setup process and an intuitive interface. With options for remote control and easy navigation through menus, users can quickly adjust settings to achieve the desired output.

Additionally, energy efficiency is a critical concern in newer projector models. The DP9295 features eco-friendly modes that reduce power consumption without compromising performance, making it a sustainable choice for organizations.

In summary, the InFocus DP9295 is a powerful digital projector that combines high resolution, excellent brightness, versatile connectivity, and user-friendly features. Its advanced DLP technology and built-in sound system make it an ideal solution for anyone looking to make a lasting impression in their presentations or displays. Whether in a classroom, boardroom, or auditorium, the DP9295 is designed to meet diverse projection needs effectively.
Top Page Image Contents