4Loosen the two captive screws that attach the lamp housing to the pro- jector.
5Detach the lamp connector from the projector by depressing the locking tab on the connector and lightly pulling it free.
WARNING:
To avoid burns, allow the projector to cool for at least 30 minutes before you replace the lamp.
Do not drop the lamp housing or touch the glass bulb! The glass may shatter and cause injury.
Be extremely careful when removing the lamp housing. In the unlikely event that the bulb ruptures, small glass fragments may be generated. The lamp housing is designed to contain these frag- ments, but use caution when removing the lamp housing. Before replacing the lamp, clean the lamp compartment and dispose of cleaning materials. Wash hands after lamp replacement. This prod- uct has a lamp which contains a very small amount of mercury. Dis- pose of it as required by local, state or federal ordinances and
lamp connector
lamp cable
lamp
housing
captive screw
regulations. For more information see www.eiae.org.
6Carefully remove the lamp housing. Dispose of the lamp in an environ- mentally proper manner.
7Install the new lamp housing and tighten the screws.
8
9Replace the lamp door.
connector
locking tab 
lamp housing
lamp cable
captive screw
10Plug in the power cord and toggle the Power switch to turn the projector back on.
11To reset the lamp hour timer, navigate to the Settings>Service menu and select Lamp Reset. See page 41 for details.
Service menu
43