InFocus RS232, W61, W60, IN5124, IN5122 manual Command Control via the Network, Lan

1.

2.

Command Control via the Network

Command Control via the Network

When the projector is connected to the network, the projector can be controlled with RS-232 commands from the computer with a web browser.

For RS-232 command information, refer to the RS-232 Communication / Network

command table (&16).

Connection

Turn off the projector and the computer.

Connect the projector's LAN port and the computer's LAN port with a LAN cable. Use the cable that fulfills the specification shown in figure (Use CAT-5

or greater LAN Cable when LAN ports are used )

3. Turn the computer on, and after the computer has started up, turn the projector on.

LAN cable (CAT-5 or greater)

LAN LAN

10