Service: to use these features, highlight them and press Select.
Factory Reset: restores all settings (except Lamp Hours) to their default after displaying a confirmation dialog box.
Test Pattern: displays a test pattern when the Blank button on the remote is pressed. To select the patterns, use the up/down arrows on the remote or keypad. Press the remote’s Blank button to exit test pattern mode.
Blue Only: turns off the Red and Green portions of the input, allowing you to properly adjust the color balance with a SMPTE color bar pattern.
ADC Calibration: allows adjustment of the calibrated ADC values so that color accuracy can be optimized. Adjust the slidebars for each value and note the change in the appropriate color. Use a component input when adjusting the Component controls.
Service Code: only used by authorized service personnel.
Maintenance
Cleaning the lens
1Apply a
Avoid using an excessive amount of cleaner, and don’t apply the cleaner directly to the lens. Abrasive cleaners, solvents or other harsh chemicals might scratch the lens.
2Lightly wipe the cleaning cloth over the lens in a circular motion. If you don’t intend to use the projector immediately, replace the lens cap.
Service menu
clean the lens
with a soft dry cloth and
31