Advanced settings

The following 4 options are for computer or HDTV sources only.

Phase: adjusts the phase of the video signal’s digital conversion.

Tracking: adjusts the frequency of the video signal’s digital conversion.

Horizontal/Vertical Position: adjusts the position of the source.

Sync Threshold Adjust: If a hardware device, such as a DVD player, is not syncing properly with the projector, adjust this option to help it to sync when connected to the projector.

TrueLife: This option refers to Faroudja’s TrueLife processing of the image. All standard definition interlaced video signals (composite, S-video and component) are routed through this processor. Extended and High Defini- tion progressive component sources are not routed though this processor by default. You can turn TrueLife on to route these signals through the proces- sor and then adjust the following 3 options:

Chroma Detail: This adjusts the color sharpness.

Luma Detail: This adjusts the overall sharpness (edge enhancement) of the Luma signal.

Chroma Delay: aligns the Luma and Chroma signals.

CCS: (Cross Color Suppression) processes the signal to remove any color information from the luma portion of the signal. It is On for all composite signals, Off for all component signals, and can be turned on or off for all S- video signals.

Film Mode: controls deinterlacing. If 2:2/3:2 Enable is selected, the deinter- lacer attempts to perform a 3:2 pulldown, assuming the source was origi- nally created on 24fps film. If the original source is 30fps film, you should select NTSC 2:2 pulldown.

Noise Reduction: adjusts signal noise reduction. Choose Off to have no noise reduction, choose Auto to have the software determine the amount of noise reduction, or choose Manual and adjust the Level. Skintone Bypass prevents the noise reduction from being performed on skin tones, thus pre- venting them from appearing overly softened.

Advanced

TrueLife

Film Mode

Noise Reduction