Adjusting the image
If necessary, adjust the height of the projector by rotating the elevator foot to extend the foot.
If necessary, rotate the leveling foot located at the rear of the projector.
Avoid placing your hands near the hot exhaust vent at the front of the projector.
Position the projector the desired distance from the screen at a 90 degree angle to the screen.
See page 6 for a table listing screen sizes and distances.
Adjust the zoom or focus.
If the image is not square, first make sure that the projector is perpendicular to the screen. If the image is larger or smaller on the top or bottom edge of the screen, press the top
Keystone button |
| to reduce the upper part of the image, and press the bottom |
Keystone button |
| to reduce the lower part. |
|
If the left or right side of the screen is larger or smaller the other, you can turn the projector to the left or to the right a few degrees to square the image.
Adjust the Contrast or Brightness in the Basic Menu. See page 25 for help with these menu adjustments.
adjust height
elevator foot
adjust distance
adjust zoom and focus
adjust keystone
adjust Basic Menu
( Basic Menu ) |
|
|
| MDL: IN124a | ||
|
|
|
|
| FW: 1.12 | |
|
|
|
|
|
|
|
Aspect Ratio | ◄ Auto ► | |||||
Auto Image | Execute | |||||
Brightness | 50 |
|
|
|
|
|
Contrast | 50 |
|
|
|
|
|
Auto Keystone | Off | |||||
Keystone | 0 |
|
|
|
|
|
Presets | Presentation | |||||
Sharpness | 16 |
|
|
|
|
|
Volume | 16 |
|
|
|
|
|
Ceiling Mount | Off | |||||
Advanced Menu |
|
|
|
|
|
|
|
|
|
|
|
|
|
9