SETTING UP THE PROJECTOR
1Place the projector on a flat surface.
•The projector must be within 10 feet (3 m) of your power source and within 10 feet of your computer.
•If you want to project from behind a translucent screen, set up the projector behind your screen. See “Rear Projection” on page 38 to reverse the image.
•If you are installing the projector on the ceiling, refer to the LP 700 Series Ceiling Mount Installation Guide that comes with the Ceiling Mount Kit for more information. To turn the image upside down, see “Ceiling” on page 38. The Ceil- ing Mount Kit is sold separately; see page 52.
2Position the projector the desired distance from the screen.
•The distance from the lens of the projector to the screen determines the size of the projected image. Figure 4 shows three projected image sizes using the lens at minimum focusing distance. For more information about image size, see “Projected Image Size” on page 58.
3Make sure the projector and your computer are turned off.
2 5 f t .
5 f t . 2 . 5 f t .
| 32.5 ft. |
3.3 ft. | 6.5 ft. |
|
FIGURE 4
Projected image size (minimum focusing distance)
NOTE: An optional extension cable, sold separately, lets you increase the distance between the projector and your computer to
70feet (21 m). See “Optional Accessories” on page 52.
7