VocoPro CDG-9000 owner manual Names and functions, Pitch Slider, KEY Control, Track Number Program

Names and functions Continued...

Front Panel

Rear Panel

10 1112 13 14 15 16

18

CONNECT

TO

MAIN UNIT

17

10.PITCH SLIDER

Use the slider to adjust the CD pitch. Slide up to decrease the pitch or down to increase the pitch.

11.OPEN/CLOSE

Press it to open and close the disc tray. The main unit also includes OPEN/CLOSE buttons. The disc tray cannot be opened during playback, so stop playback before pressing the button.

12.LOOP

Press the LOOP button to set the loop start point, press the LOOP button again to set the loop end point.

Refer to page 13 for instructions on creating a loop

13.KEY CONTROL

You can adjust source music in half-step increments, up to12 steps + (#) or - (b) from the original; or “Natural” ( ) key. Push the # button to raise the key, and the b to lower the key. Use the button to return to the original musical key. Each deck has independent KEY CONTROL, meaning that the separate outputs can be adjusted individually, and even simultaneously if necessary.

14.TRACK NUMBER PROGRAM

The numerical buttons are for quickly advancing to the track on a CD. Simply enter the number of the track to jump to that track.

15.PITCH

Use these buttons to enable or disable BPM adjustment with the pitch sliders. BPM adjustment with the pitch sliders is enabled when the PITCH LED lights. You can switch between displaying pitch or key control by holding the pitch button down for more than 0.5 second.

16.PITCH +/– The CD slows down, lowering the pitch while the (-) button is pressed. Release the button to return to the original BPM. The CD speeds up, raising the pitch while the (-) button is pressed. Release the button to return to the original BPM.

17.REMOTE CONTROLLER JACK

Connect this jack to the REMOTE CONTROLLER jack on the Player Unit using the included Control Cord.

11