GE GXRV10ABL01 owner manual Faucet Drain Tubing and Water Supply Tubing, Installations section

Step-by-step installation instructions.

Faucet Drain Tubing and Water Supply Tubing

If Option A, BASEMENT ACCESS INSTALLATION, see

Filtration Drain Connection Installations section, was used, go to step 2.

1 If Option B, C or D from page 13 or 14 was used, connect the faucet drain tubing by running the 27″ length, 3/8″ tubing from the 3/8″ faucet barb to the

drain fitting (installed in Filtration Drain Connection

Installations section). Keep this tubing run as short and straight as possible, without loops, dips or low-spots. Cut the tubing as needed and insert into the drain fitting (see Fig. 3B, 3C or 3D in the Filtration Drain Connection Installations section).

2

3

To connect the water supply tubing: Run the 1/4″ tubing (marked “WATER SUPPLY”) from the Reverse Osmosis inlet to the feed water supply fitting (see Fig. 2A or 2B, in the Feed Water Supply section). Connect the tubing as applies (Fig. 2A or 2B, in the Feed Water Supply section) and tighten the nut securely (use Teflon TapeTM to prevent leaks).

Apply the Filter replacement reminder label to one of the filter sumps between the ribs. Mark the date for filter replacement six months from the installation date.

Consumer Support Troubleshooting Tips Installation Instructions Operating Instructions Safety Instructions

Fig. 5.	* For drain line options see Filtration Drain Connection
3/8″	Installations section.

drain tubing

Water supply valve or compression fitting

Drain line*

Hot Cold

Automatic shutoff assembly

Storage tank

RO inlet

Filter Replacement

Reminder Label

16