U s i n g | t h e | P r o j e c t o r |
|
|
|
NOTE: The Manual Sync, Manual Tracking, Horiz.
Position and Vert. Position options are available only for computer sources. The projector sets these options automatically for a video source.
NOTE: The Zoom feature is only available when a computer source is active. It is not available for video sources.
Manual Tracking
The projector adjusts tracking automatically to match the video signal from your computer. However, if the display shows evenly spaced, fuzzy, vertical lines or if the projected image is too wide or too narrow for the screen, try turning Auto Image off then back on again. If the image is still bad, try adjusting the tracking man- ually:
1Turn Auto Image off.
2Highlight Manual tracking, then press either mouse button repeatedly until the fuzzy vertical bars are gone.
Horizontal position
Follow these steps to manually adjust the horizontal position:
1Turn Auto Image off.
2Highlight Horizontal position, then press the left mouse but- ton to move the image right or press the right mouse button to move the image left.
Positioning adjustments are saved when you power off the pro- jector.
Vertical position
Follow these steps to manually adjust the vertical position.
1Turn Auto Image off.
2Highlight Vertical position, then press the left mouse button to move the image down or press the right mouse button to move the image up.
Zoom
This option allows you to digitally zoom the image. Highlight Zoom, then press either mouse button. A rectangle appears on the screen. Use the arrow buttons on the keypad or the disk mouse on the remote to move the rectangle to the area you want to zoom, then click the right mouse button (not the left mouse button). The image is zoomed. To zoom further, press the right mouse button, move the rectangle to the desired area, then press the right mouse button again. You can zoom three times. To return the image to normal view, press the left mouse button. The zoom rectangle appears. To cancel zoom, activate any menu.
30