IN8606HD User’s Manual
LED Error Messages
|
|
|
|
|
| ERROR CODE MESSAGES |
| POWER LED | LAMP LED |
|
| BLUE | RED | |
|
|
| ||
| System initialization | Flashing | OFF | |
| Ready to power on (Standby) | ON | OFF | |
| System powering up | Flashing | OFF | |
| Lamp lit, normal operation | ON | OFF | |
| Cooling | Flashing | OFF | |
| Overheating | 3 blinks | OFF | |
| Thermal break sensor error | 4 blinks | OFF | |
| Lamp failure | 5 blinks | ON | |
| Lamp temperature shut down | 5 blinks | 1 blink | |
| Short circuit in lamp output detected | 5 blinks | 2 blinks | |
| End of lamp life detected | 5 blinks | 3 blinks | |
| Lamp did not ignite | 5 blinks | 4 blinks | |
| Lamp extinguished during normal operation | 5 blinks | 5 blinks | |
| Lamp extinguished during | 5 blinks | 6 blinks | |
| Lamp voltage error | 5 blinks | 7 blinks | |
| Lamp ballast error | 5 blinks | 8 blinks | |
| Ballast watt value is out of range | 5 blinks | 9 blinks | |
| (Lamp Normal & Eco mode) | |||
|
|
| ||
| Lamp ballast communication error | 5 blinks | 10 blinks | |
| 6 blinks | 1 blink | ||
| 6 blinks | 2 blinks | ||
| 6 blinks | 3 blinks | ||
| The projector case is open | 7 blinks | OFF | |
| DAD1000 error | 8 blinks | OFF | |
| Color wheel error | 9 blinks | OFF |
In the event of an error, please disconnect the AC power cord and wait for one (1) minute before restarting the projector. If the Power or Lamp LEDs are still blinking or any other situation that isn't listed in the chart above, please contact InFocus Support.
Image Problems
Problem: No image appears on the screen
1.Verify the settings on your notebook or desktop PC.
2.Turn off all the equipment and power everything up again. The projector should be turned on last.
Problem: The image is blurred
1.Adjust the Focus on the projector.
2.Press the Auto button on the remote control.
3.Ensure the
4.Check that the projector lens is clean.