InFocus AA0021 manual Declaration of Conformity, Trademarks, FCC Warning, Canada, Agency Approvals

Page 2
Declaration of Conformity

Declaration of Conformity

Manufacturer: InFocus Corporation, 13190 SW 68th Parkway, Suite 200, Portland, Oregon 97223-8368 USA

We declare under our sole responsibility that this projector conforms to the following directives and norms:

ErP Directive 2009/125/EC EMC Directive 2004/108/EC Low Voltage Directive 2006/95/EC R&TTE Directive: 1999/5/EC

EMC: EN 55022, EN 55024, EN 61000-3-2, EN 61000-3-3

Safety: IEC 60950-1: 2005 (MOD)

ETSI: EN 300 440, EN 301 489

The receiver portion of this product is a Category III device, as specified in EN 300 440.

Trademarks

Apple, Macintosh, and PowerBook are trademarks or registered trademarks of Apple Computer, Inc. IBM is a trademark or registered trademark of International Business Machines, Inc. Microsoft, PowerPoint, and Windows are trademarks or registered trademarks of Microsoft Corporation. Adobe and Acrobat are trademarks or registered trademarks of Adobe Systems Incorporated. DLP®, DLP Link and the DLP logo are registered trademarks of Texas Instruments and BrilliantColor™ is a trademark of Texas Instruments. InFocus, In Focus, and INFOCUS (stylized) are either registered trademarks or trademarks of InFocus Corporation in the United States and other countries.

NOTE: This product is covered electrical and electronic equipment under the European Union's Waste from Electrical and Electronic Equipment ("WEEE") Directive (2002/96/EC). The WEEE Directive requires that covered equipment be collected and managed separately from typical household waste in all EU member states. Please follow the guidance of your local environmental authority or ask the shop where you purchased the product for collection or recycling options.

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and receiver.

--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

--Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by InFocus Corporation may void authority to operate the equipment.

Canada

This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

Agency Approvals

cTUVus

Other specific Country Approvals may apply. Please see product certification label. This document applies to regulatory model AA0021.

Input ratings: 100-240Vac, 3.9A, 50-60Hz

InFocus reserves the right to alter product offerings and specifications at any time without notice.

1

Image 2
Contents 010-0752-02 FCC Warning Declaration of ConformityTrademarks CanadaTable of Contents Important Operating Considerations for Safety Introduction Product specificationsAccessories Online registrationConnector panel Size Positioning the projectorDiagonal Screen WidthUSB Mini B connection Connecting a computer sourceConnecting power VGA connectionDisplaying an image Adjusting the image 1610 screen 43 mode 1610 mode Native mode What is Aspect Ratio?43 screen Composite video connection Connecting a video deviceVideo device connections Component video connectionLiteBoard Wand Charging the Wand’s BatteryHow to Use the Wand Wand Position and Avoiding ShadowsHow to Hold the Wand Using More than One WandWand Features Battery LightLithium Battery Information USB ConnectorReset Button LiteBoard Wand MenuTroubleshooting LiteBoard Shutting down the projector Troubleshooting your setupTable 2 Status indicator light behavior and meaning Screen Save TimeRestart laptop Startup Screen AStartup Screen USB A USB mini BPage Red Gain For a laptop, disable laptop monitor or turn- on dual-display modeAdjust horizontal or vertical position in Advanced Picture menu Green GainSharpness Correct imageMaximum Aspect RatioCOLOR COLORStartup Screen Startup Screen Lamp lightUsing the remote control Troubleshooting the remoteTroubleshooting Audio Using the audioUsing the projector’s speakers Signal Playing sound through the projectorAbout the microphone input ParameterUsing the keypad buttons Presentation features Optimizing computer imagesDynamic Messaging Optimizing video imagesCustomizing the projector Using the menus Basic Picture menu Advanced Picture menu Setup menu Network Factory Reset... Performs factory resetDisable Snapshot allows the user to disable the snapshot capability To enter the PIN at projector startup To change the PINStatus and Service menu Using LitePort Displaying JPEG imagesTo convert a PowerPoint presentation to a PtG presentation Troubleshooting LitePortDisplaying PtG presentations To display the PtG presentationLogin LiteShowSetting up a LAN connection Default PasswordDownload Admin MenuLiteShow Menu Options System StatusAMX Control System Enable control by AMX systems Menu Sample Admin Network menu Menu Sample Basic Projector Control menuDownloading the LiteShow Utility LiteShow Download menu LiteShow ShortcutTo display your computer/PDA image over the LAN LiteShow Toolbar To moderate multiple usersTo control the projected image LiteShow Moderator ControlUsing the security lock MaintenanceCleaning the lens Replacing the projection lamp 1 Turn off the projector and unplug the power cord INDEX Numerics