Onkyo CR-445 Before Using the CD Receiver, Installing the Batteries, Using the Remote Controller

Before Using the CD Receiver

Installing the Batteries

1Open the battery compartment, as shown.

Using the Remote Controller

When you operate the remote controller, point it at the CD receiver’s remote control sensor.

Remote control sensor

		m
		5
		.
	rox
p		.)
p
A		ft
	6
1
(

2Insert two batteries (R6 / AA) into the battery compartment.

Carefully follow the polarity diagram (positive (+) and negative (–) symbols) inside the battery compartment.

3After the batteries are installed and seated correctly, attach the compartment cover.

Notes:

•If the remote controller doesn’t work reliably, try replacing the batteries.

•Don’t mix new and old batteries or different types of batteries.

•If you intend not to use the remote controller for a long time, remove the batteries to prevent damage from leakage or corrosion.

•Expired batteries should be removed as soon as possible to prevent damage from leakage or corrosion.

Notes:

•The remote controller may not work reliably if the CD receiver is subjected to bright light, such as direct sunlight or inverter-type fluorescent lights. Keep this in mind when installing.

•If another remote controller of the same type is used in the same room, or the CD receiver is installed close to equipment that uses infrared rays, the remote controller may not work reliably.

•Don’t put anything, such as a book, on the remote controller because the buttons may be pressed inadvertently, thereby draining the batteries.

•The remote controller may not work reliably if the CD receiver is installed in a rack behind colored glass doors. Keep this in mind when installing.

•The remote controller will not work if there’s an obstacle between it and the CD receiver’s remote control sensor.

6