Gateway 205 Maintaining the projector, Changing the lamp module, To replace the lamp module

Page 29

Maintaining the projector

Maintaining the projector

The only user-replaceable part in the projector is the lamp module. Contact Gateway Technical Support for any additional service or repair.

Warning

To prevent electric shock, do not open the projector case. There are no user-replaceable parts inside. Contact Gateway Technical Support for service or repair.

Changing the lamp module

You should replace the lamp module and reset the lamp timer in the projector every 1500 hours to maintain the best possible display image. Do not use a lamp module past the rated lamp life.

Warning

The high-pressure lamp module may explode if handled incorrectly. Make sure that the projector is turned off, power is disconnected, and the lamp is completely cool (minimum of 45 minutes) before replacing the lamp module.

To replace the lamp module:

1

2

3

4

Turn off the projector and wait for the fan to stop.

Disconnect the power cord and all other external cables.

Let the projector lamp cool completely (approximately 45 minutes).

Turn the projector over so the bottom is facing up.

www.gateway.com

27

Image 29

Contents Contents Page Using Gateway Projector Features Icon Description Projector frontProjector back Projector back Projector top Projector top Projector bottom Cable Description CablesCable To insert batteries in the remote control Remote controlRemote front Power Remote back Still To set up the projector Setting up the projectorTo connect the projector to your computer Connecting componentsConnecting to your computer Using the Gateway 205 Projector Connecting to a DVD player or VCR Using the Gateway 205 Projector To connect the projector to a satellite dish Connecting to a satellite dishTo start the projector Operating the projectorStarting the projector OSD options To adjust the OSD settingsOSD Menu Description OSD menusOSD Menu To shut down the projector Shutting down the projectorTo replace the lamp module Maintaining the projectorChanging the lamp module Remove the lamp module retaining screw Maintaining the projector To reset the lamp timer Cleaning the projectorCarrying cases AccessoriesFirst steps TroubleshootingNo power Common problems and solutionsDisplay image is wider on the top or bottom On-screen status messages Power LED Lamp LED Problem Possible CauseLED status Specifications Diagonal Width Height Display size chartResolution Horizontal Sync Vertical Sync Remark Timing chartImportant safety information Safety Regulatory, and a Legal InformationCare during use Setting up the projectorReplacement parts and accessories FCC declaration of conformity Regulatory compliance statementsUnited States of America Laser Radiation CanadaCalifornia Proposition 65 Warning Industry Canada IC Unintentional emitter per ICES-003Trademark Acknowledgments Macrovision statementAll Rights Reserved Appendix a Safety, Regulatory, and Legal Information