Gateway 205 specifications Cleaning the projector, To reset the lamp timer

Page 32

Using the Gateway 205 Projector

11

12

Turn the projector over.

Connect the power cable and all external cables.

To reset the lamp timer:

1 Press the POWER button on the top of the projector twice, a warning message appears.

2 Press the AUTO and BLANK buttons at the same time. A lamp hour icon will appear on the screen.

3 Press the AUTO button to reset the lamp timer.

Cleaning the projector

Keeping the projector clean and the vents free from dust helps keep it performing at its best.

Warning

Make sure that the projector is off, power is disconnected, and the lamp is completely cool (minimum of 45 minutes) before cleaning the projector.

Cleaning the exterior

Always turn off the projector and wait for it to cool before cleaning it.

Use a damp, lint-free cloth to clean the projector case. Do not use abrasive or solvent cleaners because they can damage the finish.

The projector is cooled by air circulated through the vents on the case, so keep the vents free of dust. With the projector turned off and unplugged, brush the dust away from the vents with a damp cloth. Be careful not to drip any water into the vents. Do not attempt to clean dust from the inside the projector.

Cleaning the projector lens

Always turn off the projector and wait for it to cool before cleaning the projector lens.

Use a soft cloth and glass cleaner to clean the projector lens. Squirt a little cleaner on the cloth (never directly on the lens), and wipe the lens with the cloth.

30	www.gateway.com

Image 32

Contents Contents Page Using Gateway Projector Features Projector front Icon DescriptionProjector back Projector back Projector top Projector top Projector bottom Cables Cable DescriptionCable Remote control To insert batteries in the remote controlRemote front Power Remote back Still Setting up the projector To set up the projectorTo connect the projector to your computer Connecting componentsConnecting to your computer Using the Gateway 205 Projector Connecting to a DVD player or VCR Using the Gateway 205 Projector Connecting to a satellite dish To connect the projector to a satellite dishTo start the projector Operating the projectorStarting the projector To adjust the OSD settings OSD optionsOSD menus OSD Menu DescriptionOSD Menu Shutting down the projector To shut down the projectorTo replace the lamp module Maintaining the projectorChanging the lamp module Remove the lamp module retaining screw Maintaining the projector Cleaning the projector To reset the lamp timerAccessories Carrying casesTroubleshooting First stepsCommon problems and solutions No powerDisplay image is wider on the top or bottom On-screen status messages Power LED Lamp LED Problem Possible CauseLED status Specifications Display size chart Diagonal Width HeightTiming chart Resolution Horizontal Sync Vertical Sync RemarkSafety Regulatory, and a Legal Information Important safety informationCare during use Setting up the projectorReplacement parts and accessories FCC declaration of conformity Regulatory compliance statementsUnited States of America Canada Laser RadiationCalifornia Proposition 65 Warning Industry Canada IC Unintentional emitter per ICES-003Trademark Acknowledgments Macrovision statementAll Rights Reserved Appendix a Safety, Regulatory, and Legal Information