3.Wait at the least one hour for the lamp and lamp unit to cool down.
4.Read the caution and warning labels on the unit.
Lamp cover
A
WARNING
| MODEL NO. |
| AC 120V 60H 2.0A |
ATTENTION : | ATTENTION CHAUD : |
AB
For USA
WARNING
THIS COVER IS PROVIDED WITH
INTERLOCK TO REDUCE THE RISK OF
EXCESSIVE ULTRAVIOLET RADIATION.
DO NOT DEFEAT ITS PORPOSE OR
ATTEMPT TO SERVICE WITHOUT
REMOVING COVER COMPLETELY.
For Europe
CAUTION HOT
5. Remove the lamp cover screw. | 8. Holding the handle and pull the lamp unit out | 11. Install the lamp cover back in its original |
| toward your side. | position and fasten with the fastening screw. |
|
| (a) |
| Lamp unit |
|
(b)
6.Remove the lamp cover in the direction of the arrow.
9.Install a new lamp unit in position securely.
ENGLISH
UNPLUG THE POWER CORD AND
WAIT 60 MINUTES BEFORE
CHANGING THE LAMP.
ATTENTION CHAUD
DEBRANCER LE CORD ON
D'ALIMENTION ET ATENDER 60
MINUTES AVANT DE CHANGER
LAMPE.
WARNUNG HEISS
ZIEHEN SIE DEN NETZSTECKER
AB UND WARTEN SIE 60 MINUTEN,
BEVOR SIE DIE GLUHLAMPE
WECHSELN.
B
For USA
CAUTION : HIGH PRESSURE LAMP | CAUTION HOT : UNPLUG | M |
MAY EXPLODED IF IMPROPERLY HANDLED. | THE POWER CORD AND WAIT | |
REFER SERVICING TO QUALIFIED SERVICE | 60 MINUTES BEFORE CHARGING |
|
PERSONNEL. | THE LAMP. |
|
ATTENTION : LA LAMPE SOUS | ATTENTION CHAUD : |
|
HAUTE PRESSION PEUT SI ELLE, N'EST | DEBRANCER LE CORD ON |
|
PAS MANIPULEE CORRECTEMENT, | D'ALOMENTION ET ATENDER |
|
CONFIER L'OPERATION A UN | 60 MINUTES AVANT DE |
|
PERSONNEL D'ENTRETIEN QUALIFIE. | CHANGER LAMPE. |
|
For Europe
CAUTION | VORSICHT : | |
HIGH PRESSURE LAMP MAY EXPLODED IF | BEI FALSCHER HANDHABUNG M | |
IMPROPERLY HANDLED. REFER SERVICING | KANN DIE HOCHDRUCKLAMPE | |
TO QUALIFIED SERVICE PERSONNEL. | EXPLODIEREN UBERLASSEN | |
ATTENTION | SIE WARTUNGSARBEITEN | |
NUR FACHPERSONAL. | ||
LA LAMPE SOUS HAUTE PRESSION PEUT | ||
| ||
EXPLOSER SI ELLE, N'EST PAS MANIPULEE |
| |
CORRECTEMENT, CONFIER L'OPERATION |
| |
A UN PERSONNEL D'ENTRETIEN QUALIFIE. |
|
Lamp cover
7.Open the cover sheet and remove the two screws (slotted head screwdriver required) that lock down the lamp unit. Do not remove any other screws.
Cover sheet
10.Lock the lamp unit in place with the two screws removed in step 7. Press on the handle until it folds over and close the cover sheet.
12.Plug in the video projector and turn on the power and project the image.
•If the lamp is replaced before reaching its
2000 hours lamp life, see “Reset Lamp Life” (☞ P.27).
•If the lamp is replaced after reaching its
2000 hours lamp life, see “Initialize the Lamp Life” (☞ P.28).
29