Lumens Technology VC-G50 quick start Camera Address Selector, System Switch

Page 32

7.1.2 IR SELECT

ID	Setting
1

2

3

7.1.3 Camera Address Selector

Setting	Function
	Descriptions
0~7	ID 0~7
8~9	Reserved

7.1.4 System Switch

	Setting			Function Descriptions
	DIP 1			RS-232C/RS-422 selector
	DIP 1			OFF : RS-232C / ON : RS-422
				OFF : RS-232C / ON : RS-422
	DIP 2			Infrared signal output switch
	DIP 2			OFF : Off / ON : On
				OFF : Off / ON : On
	DIP 3			Communication baud rate selector
	DIP 3			OFF : 9600 / ON : 38400
				OFF : 9600 / ON : 38400
	DIP 4			Reserved

English - 31

Image 32

Contents Camera Installation Guide English Table of Contents DIP Switch Setting Copyright Information Safety Instructions  Precautions  FCC Warning EN55022 CE Radiation Warning  KCC WarningPackage Contents Overview Description of LED indicatorProduct Overview Instruction for installation Preparation before installationInstruction for installation Would like to install VC-G50 on the deskWould like to install VC-G50 on the ceiling DimensionSize Diagram Page Bottom of machine English Precautions for installation Installation stepsPage How to remove Connecting the device Image outputConnecting to a Hdtv 3G-SDI Controlling VCs with the computer Remote Control and Setting Menu Functions of remote controlSetting menu Manual Speed 0dBManual Gain Gain Limit 30dBOff AutoWhite BalanceImage Mode Mode5Mode1 LoadPreset Speed Tilt Down 30~0Zoom Limit 150 deg/secFactory Reset StatusWould like to switch to VC-G50 Would like to adjust the shooting angle of the lensWould like to save the current lens position data Would like to clear the saved position dataWould like to adjust the focal length Would like to adjust the focus speedWould like to set the image mode Would like to freeze imagesWould like to rotate the image Would like to change the camera directionDIP Switch Setting Output SwitchSystem Switch Camera Address SelectorUse RS-422 Connection RS-422 Connection1 RS-422 Pin Description Page Troubleshooting RS-232/RS422