Onkyo T-4555 instruction manual Troubleshooting, Power, Audio, Tuner

Page 26

Troubleshooting

If you have any trouble using the T-4555, look for a solution in this section.

If you can’t resolve the issue yourself, try resetting the T-4555 before contacting your Onkyo dealer.

To reset the T-4555 to its factory defaults, turn it on and, while holding down the [MEMORY] button, press the [STANDBY/ON] button. “Clear” will appear on the display and the T-4555 will enter Standby mode.

Note that resetting the T-4555 will delete your radio presets and custom settings.

Power

Can’t turn on the T-4555.

•Make sure that the power cord is properly plugged into the wall outlet (see page 15).

•Unplug the power cord from the wall outlet, wait 5 seconds or more, then plug it in again.

Audio

There’s no sound.

•Make sure your amplifier’s volume control is not set to minimum.

•Check all connections and correct as necessary (see pages 10 to 14).

Tuner

Reception is noisy, stereo FM reception suffers from hiss, or the STEREO indicator doesn’t light up when tuned to a stereo FM station.

•Check the antenna connections (see page 10).

•Change the position of the antenna (see page 16).

•Move the T-4555 away from a nearby TV or computer.

•Cars or airplanes can cause noisy interference.

•The radio signal will be weakened if it has to pass through a concrete wall before reaching the antenna.

•Try selecting Manual Tuning mode (mono) (see page 15).

•Move power cords and speaker cables as far away as possible from the antenna.

•When listening to an AM station, noise may be heard when you operate the remote controller.

•If none of the above improves the reception, install an outdoor antenna (see page 11).

If a power outage occurs or the power cable is disconnected:

• If the preset stations are lost, preset them again (see page 22).

Can’t adjust the frequency of the radio.

• Use the TUNING/CH []/[ ] buttons to change the frequency of the radio (see page 15).

RDS doesn’t work.

•The FM station you are tuned to doesn’t support RDS.

•Install an outdoor FM antenna (see page 11).

•Change the position or direction of your outdoor FM antenna (see page 11).

•Move the FM antenna as far away as possible from fluorescent lights (see page 11).

26

Page 25 Page 27
Image 26
Page 25 Page 27
Contents
Contents Important Safety Instructions AvisPrecautions PowerEuropean Model FeaturesSupplied Accessories ModelContents Display Getting to Know the T-4555Front Panel Getting to Know the T-4555 Rear PanelRemote Controller Remote ControllerAiming the Remote Controller Before Using the T-4555Installing the Batteries Open the battery compartment, as shownConnecting the AM Loop Antenna Connecting AntennasConnecting the Indoor FM Antenna Attach the FM antenna, as shownConnecting an Outdoor FM Antenna Connecting AntennasConnecting the DAB Antenna C-DAB Tuner Board Only Connecting an Outdoor AM AntennaBefore Making Any Connections Connecting the T-4555Connecting to an Amplifier About the System FunctionsConnecting the T-4555 Connecting the 12V Trigger JacksControlling Other Out-of-range Components Controlling the T-4555 When It’s Out of RangeControlling Components That Are Out of Range Listening to AM and FM Radio Setting the Display BrightnessTurning On and Listening to AM and FM Radio Turning On the T-4555Press the Direct Tuning but Tuning into Stations by FrequencyAdjusting the Antennas Turning On and Listening to AM and FM RadioUsing RDS Program Types Used in Europe PTYListening to Traffic Information TP Displaying Radio Text RTFinding Stations by Type PTY Selecting DAB for the Very First Time Using the Auto Tuning Function ManuallyListening to DAB Digital Radio Selecting DAB StationsDisplaying DAB Radio Information DAB SetupListening to DAB Digital Radio St. List Station ListingBand Scan ModeDRC Value Band III 5A-13F Selecting Presets Using Presets Presetting Your Favorite Stations Deleting PresetsChanging the T-4555’s Remote ID Changing the Remote Controller’s IDChanging the Remote ID Use the Up and Down Arrow / buttons to select AM Freq AM Frequency Step SetupOptional Tuner Boards Buttons to selectOptional Tuner Boards Installing a BoardPower cord from the wall outlet Turn off the T-4555, and then unplugAudio TroubleshootingPower TunerOthers TroubleshootingSpecifications 3 4 4 3 1
Top Page Image Contents