JVC GM-V42E manual Basic Operations, Daily Operations

Basic Operations

Rear View

1

POWER

RM–C579 REMOTE CONTROL UNIT

OFF POWER ON

DISPLAYASPECT

DISPLAY

	INPUT SELECT
3	A	COMPO.
		/(RGB B)
	VIDEO
	B	RGB A
	MUTING	VOLUME

MUTING

MENU/EXIT

2

4

Daily Operations

1 Turn on the main power.

Set POWER on the back of the Monitor to “(on)”. The POWER lamp on the upper left of the front panel glows orange.

2 Turn on the power.

Press POWER ON on the remote control to turn the power on.

The POWER lamp changes to glow green.

•You can also use the button on the front panel (lower right) to turn on the Monitor.

3 Select an input.

Select the desired input by pressing INPUT SELECT (VIDEO A, VIDEO B, COMPO./(RGB B) and RGB A).

•You can also select the input by pressing INPUT on the Monitor. Each time you press the button, the input mode changes in sequence.

VIDEO A		VIDEO B
RGB A	COMPONENT or RGB B

•Only for GM-V42PCE, GM-V42PCEG and GM-V42PCEB: You can select only RGB A.*

Ex. When selecting “VIDEO A” input

V I D E O A

N T S C

Input selected

Input video signal

Note:

•To select “COMPONENT” or “RGB B,” you need to set the “RGB/COMPO.” setting correctly.

4 Adjust the volume.

V O L U M E: 1 0

– +

Note:

•While no menu is displayed, you can adjust the volume by pressing 2 / 3 on the Monitor.

To turn off the volume immediately

Press MUTING.

“MUTING ON” is displayed, and the sound goes out. Pressing the button again resumes the previous volume level.

To make the screen indication appear

Press DISPLAY.

The types of input and signal are indicated on the screen for about 3 seconds.

You can also make the screen indication appear using menus (page 24).

*Only for GM-V42PCE, GM-V42PCEG and GM-V42PCEB: You need to install the video input unit (IF-C42P1G), which is separately purchased, to select “VIDEO A,” “VIDEO B,” and “COMPONENT (or RGB B)” as the input.

14