12 |
|
Adjust the focus and zoom. |
|
If the image is square but not centered | adjust focus |
adjust it using the lens shift dials. | adjust zoom |
horizontal lens shift | |
| vertical lens shift |
Rotate the elevator feet if needed for granular adjustment of the projector‟s height. Avoid placing your hands near the hot exhaust vent at the side of the projector.
Adjust the Contrast or Brightness in the Basic Picture menu.
Adjust the volume on your stereo receiver. | adjust volume |
Your projector has been factory optimized for | adjust Picture menu options |
excellent performance no matter what the source. | including Aspect Ratio |
However, if you wish to make further changes you |
|
can optimize the image using on screen menus. |
|
Adjust the Contrast, Brightness, Color, Tint, or Aspect Ratio
in the Picture menu. See page17 for help with the menus and these adjustments.
For Aspect Ratio, keep in mind that DVD players must be configured for 16:9 in order to view the highest quality image. For more information regarding Aspect Ratio, see page 9.
Shutting down the projector
Screen Save Time
You can make the black screen appear after a preset number of minutes by turning on the Screen
Save Time feature in the Setup menu...
Auto Off Time
The projector has an Auto Off Time feature that automatically turns the projector off if no active sources are detected and no user interaction with the projector is performed for 30 minutes. By default, this feature is off. You can change the length of time.
Turning off the projector
To turn the projector off, press the Power button on the remote or keypad. The lamp turns off and the LED blinks amber for 10 seconds while the fans continue to run to cool the lamp. When the lamp has cooled, the LED lights amber and the fans stop. Unplug the power cable to completely power off the projector.
NOTE: Once the projector has been turned off, you must wait for one minute before turning the projector on again. This allows the lamp to properly cool and extend the lamp life up to 3000 hours). The LED light is solid green when the cooling process is complete.
NOTE: The biggest cause of early lamp failure is not allowing the lamp to cool properly, either from power failures or disconnecting power to the projector before the fan can cool the lamp properly.