4
Important Operating Considerations for Safety
Refer to this guide for proper startup and shutdown procedures.
•Follow all warnings and cautions in this manual and on the projector.
•Place the projector in a horizontal position no greater than 8 degrees off axis.
•Locate the projector at least 4' (1.2m) away from any heating or cooling vents.
•Do not block ventilation openings. Locate the projector in a well ventilated area without obstructions to intake or exhaust vents. Do not place the projector on a tablecloth or other soft covering that may block the vents.
•Do not place the projector in direct sunlight, humid, greasy or dusty places or in places where the projector may come into contact with smoke or steam.
•Do not touch the exhaust vents. This area will become hot while the projector is being used. Be sure children are kept away from this area.
•Do not look directly into the lens while the projector is being used. Be especially careful that children do not stare directly into the lens.
•Do not push objects of any kind into this projector through its venting as object may touch dangerous voltage that could result in a fire or electrical shock.
•Do not drop the projector.
•Do not spill liquid on the projector. Spilled liquid may damage the projector.
•Do not place any object on the projector.
•Do not stand or step on the projector.
•Use the power cord provided. Connect the power cord to a receptacle with a protective safety (earth) ground terminal. The AC power cord has a
•When disconnecting the power cord, hold the plug, not the cord. Unplug the projector from the wall outlet, if the projector is unused for an extended time.
•Wash hands after handling the cables supplied with this product.
•The projector remote control uses batteries. Make sure the batteries polarity
•Use a Knoll approved ceiling mount kit for proper fitting, ventilation and installation. The projector warranty does not cover any damage caused by use of
•When the projector is ceiling mounted, wear protective eyewear to prevent eye injury before opening lamp door.
•The projector must be installed by a qualified professional in order to ensure proper operation and reduce the risk of hazards or injury. It is not recommended you install the projector yourself.
•Refer all service to qualified service personnel. Servicing your own projector can be dangerous to you and will void the warranty.
•Only use replacement parts specified by Knoll. Unauthorized substitutions may result in fire, electrical shock, or injury, and may void the warranty
•Only genuine Knoll lamps are tested for use in this projector. Use of non Knoll lamps may cause electrical shock and fire, and may void the projector warranty.
•Hg – Lamp contains mercury. Manage in accordance with local disposal laws. See www.lamprecycle.org.
•The projector uses a
In the unlikely event of a lamp rupture, particles may exit through the projector vents. Keep people, food, and drinks out of the "keep out" area under and around the projector, as indicated by the "X" areas below.