Bosch Appliances UML-273-90 Installing the Monitor, Ventilation, Connecting Power

Bosch High Performance	Installing the Monitor en 29
HD LED Monitors

5Installing the Monitor

This chapter outlines the procedures to install the monitor. A qualified service person should install the monitor and adhere to all local codes.

5.1Ventilation

To prevent overheating, ensure that the ventilation openings on the rear of the monitor are not covered.

5.2Connecting Power

The Bosch Flat Panel CCTV monitors are delivered with a 3-pole US-style power cord and a 3-pole Euro-style power cord. Use the US-style power cord where 120 VAC, 60 Hz power is available; use the Euro-style power cord where 230 VAC, 50 Hz power is available. The monitor automatically adjusts to either power input voltage.

5.3Connecting the Composite Video Signal to the Monitor

There is one (1) BNC connector located on the rear panel of the monitor for composite video input and one (1) BNC connector for composite video output (Refer to Rear Panels, page 20). Note: All video inputs are passive loop-through. The impedance is automatically set to 75 ohm by the input of the signal on the input connector, while operating in a single connection mode (refer to , page 35). If a cable is also connected to the output connector, the video signal can be passed on to another monitor connected to it via the passive loop-through function. Up to three (3) monitors may be connected in this manner (refer to , page 35).

Note: To select AV1, press VIDEO SOURCE/ENTER, and then press the Up or Down arrow button, located on the front of the monitor.

Bosch Security Systems, Inc. Installation Manual 2013.02 3.0