Elmo HV-100XG instruction manual Zoom Lamp, RGB Output

No.	Name	Function
14	Digital Zoom Button	To operate digital zoom. Use the Digital zoom after
	[DIGITAL ZOOM]	moving the camera head to the lowest horizontal
		position (the minimum shooting area), and the image
		is expanded even more. The zoom button
		[TELE]/[WIDE] can change the size of an object in
		display on the monitor screen. Pressing [TELE] and
		[WIDE] buttons together resets the digital zoom to
		the initial state (non-action).
		Note: - The digital zoom will degrade the
		image quality.
		- Turning ON the power supply resets
		the digital zoom to the initial state
		(non- action).
15	Zoom Lamp	To indicate the digital zoom operation. When the
		digital zoom is in operation, this lamp is
		flickering/lighting.
16	Gain Button [GAIN]	To adjust the image brightness by manipulating the
		gain button [UP]/ [DOWN]. Pressing [UP] and
		[DOWN] buttons together resets the gain to the initial
		state.
		Note: - Turning ON the power supply resets
	Auto White Balance	[GAIN] to the initial state.
17		To turn the auto white balance operation ON/LOCK.
	Switch [AWB]	Turning this switch LOCK locks the white balance.
		Note: - If the auto tracking is disabled for
		some objects or the source of light,
		shoot a white object to operate the
		white balance, and then turn LOCK
		the auto white balance switch [AWB]
		before using.

18Auto Electronic Shutter To turn the auto electronic shutter ON/OFF.

		Switch [AES]		Note: - If the image flickers, turn the auto
				electronic shutter switch [AES] OFF.
19		Gamma Value Selection		The gamma value selection switch is used for
		Switch [	]	adjusting the brightness tone to that of a unit in
				connection. In normal use, this switch is set at
				[NORM.]. According to the unit in connection or the
				object, select the optimum position.
				[HIGH] . . . . To intensify the contrast. This level fits
				when the object is document etc.
				[NORM.] . . Normal
				[LOW] . . . . To diminish the contrast. This level fits
				when a CRT monitor is connected.
20		RGB-in Terminal		To connect other image output unit. The image is
		[RGB INPUT]		output from the RGB-out terminal [RGB OUTPUT]
				when the image input selection switch [INPUT] is set
				accordingly.
	21	RGB-out Terminal		To output the image to the monitor or protector in
		[RGB OUTPUT]		connection to this terminal.
				- 10 -