Elmo HV-100XG instruction manual Setting UP and Storing

2. SETTING UP AND STORING

2-1 SETTING UP

Gently release the clipped area (as marked with arrow) of the right and left stages as illustrated.

Note:- It may be damaged by un- latching the stages putting hands on other position not shown by arrows.

-When the accessory case is housed inside, be careful not to drop it.

OPEN OPEN STAGE STAGE

Connect the RGB-out terminal [RGB		Latch parts
OUTPUT] of the Presenter to the monitor/
projector with the RGB cable (supplied).
Note: - Before starting connection, turn
OFF the power supply to each unit.
Connect the AC adaptor, and turn the power
switch [POWER] to ON.		Convex part
Instruction for location:	Convex	of the base unit
- Please note that the image may be	part of the
	arm side	Convex part
affected by unsightly shadows caused
from other lights in the room or from the		of the main
		stage side
outside. This effect can usually be
eliminated or reduced by repositioning
the HV-100XG being mindful of the
ambient lights.

		Concave part of
2-2	STORING	the main stage
		AC adaptor
	Make sure that the power switch [POWER] is
	OFF, and then remove all cords connected to
	the Presenter.
	Move the camera head to be in line with the
	arm horizontally.	Analog RGB
	House the auxiliary stage inside the main	cable
	stage, and then fold the main stage. At this
	time, house the accessory case inside the stage.	<Accessory case>
	Note: - Confirm that the accessory
	case is closed firmly before
	housing.
	Make sure that all movable parts are put
	back to storing position accordingly.
	- 11 -