1
5 | 6 | 7 |
4
2
3
Figure 4.
Figure 4:
Connecting the mouse cable and stereo jack (PC)
•1 Back panel of computer
•2 PC monitor
•3 EVC cable
•4 PC adapter
•5 Stereo jack cable
•6 PS/2 mouse for PC
•7 RS232 mouse for PC
1.3Insert batteries in the remote control
Figure 5 shows the remote control with the battery lid removed. Slide off the battery lid and insert the batteries with the + and - poles correct. Slide the battery lid back on again.
Figure 5 Inserting batteries in remote con-
trol
1.4Connect projector to power supply
Plug in your projector. Do not plug it into a switched outlet. Your Zenith projector is designed to operate on standard current, 120- volt, 60 Hertz AC. Do not attempt to operate it on DC current.
2.Important information
The registration card or copy of invoice is your proof of purchase. Please make sure that the registration card is returned in order to get the warranty service you are entitled to
NOTE! Please use caution when transporting the unit.
WARNING! Tampering with or opening the unit can be dangerous. For replace- ment of the lamp, see the instructions support with the replacement lamp. Maintenance should be performed by an authorized Zenith dealer or service cen- ter. Please contact your local dealer with any service or maintenance ques- tions you may have.
1 0 |
| 1 1 |
|
|
|