Texas Instruments manual 2. TUSB3210 Evaluation Board

Page 11

Running Title—Attribute Reference

TUSB3210 device. A USB cable should be plugged into a USB port on a PC or into a USB hub and connected to the TUSB3210 EVM type-B connector (U3).

Figure 1−2. TUSB3210 Evaluation Board

Figure 1−3. TUSB3210 EVM Connected to a Compact Flash Daughterboard

Chapter Title—Attribute Reference

1-3

Image 11

Contents User’s Guide Products Applications Important NoticeEVM Important Notice EVM Warnings and Restrictions About This Manual Read This FirstTrademarks Tables ContentsViii Topic Hardware and Software RequiredHardware Overview Equipment−2. TUSB3210 Evaluation Board −4. TUSB3210 Printed-Circuit Board REV 1.1-Top Side −5. TUSB3210 Printed-Circuit Board REV 1.2-Top Side Quantity Reference Part Bill of MaterialsSchematic Diagram Page Eeprom Gpio ConnectorEVM Operation Light Emitting Diodes LEDs TUSB3210 SetupPower Supplies Interfaces and USB PortJumper/Switch Jumper/Switch Description Jumpers and SwitchesGpio Connector −1. Gpio Connector NPN NPN