Onkyo TX-SR573 Connecting Speaker Set A, Connecting a Powered Subwoofer, Connecting Speaker Set B

Page 17

Connecting Speaker Set A

Connecting Your Speakers—Continued

Connecting Speaker Set A

1	Strip 5/8" (15 mm) of insu-	5/8" (15 mm)
	Strip 5/8" (15 mm) of insu-
	lation from the ends of the
	lation from the ends of the
	speaker cables, and twist
	the bare wires tightly, as
	shown.

2Unscrew the terminal. Fully insert the bare wires. Make sure that the bare wire is touching the inside of the pole. Screw the terminal tight.

Connecting a Powered Subwoofer

Using a suitable cable, connect the AV receiver’s SUB- WOOFER PRE OUT to the input on your powered sub- woofer. If your subwoofer is unpowered and you’re using an external ampliﬁer, connect the SUBWOOFER PRE OUT to the amp’s input.

Note:

Make sure the plugs are pushed in all the way.

This hookup diagram shows which speaker should be con- nected to each pair of terminals.

If you’re using only one surround back speaker, connect it to the left (L) SURROUND BACK SPEAKERS terminals.

Connecting Speaker Set B

1	Strip 3/8" (10 mm) of insu-	3/8" (10 mm)
	Strip 3/8" (10 mm) of insu-
	lation from the ends of the
	lation from the ends of the
	speaker cables, and twist
	the bare wires tightly, as
	shown.
2 While pressing the lever, insert
	the wire into the hole, and then
	release the lever.
	Make sure that the terminals are
	gripping the bare wires, not the
	insulation.

Note:

While speaker set B is on, speaker set A is reduced to 5.1-channel playback.

Speaker Set A

Front right

Front left

speaker

speaker

Center

speaker

Front right	Front left
speaker	speaker

Speaker Set B

Powered	Surround	Surround	Surround	Surround
subwoofer	back right	back left	right	left
	speaker	speaker	speaker	speaker

17

Image 17

Contents TX-SR573 ContentsInstruction Manual AV ReceiverAVIS Important Safety InstructionsMemory Backup Precautions4.Power For U.S. modelsFeatures Supplied AccessoriesRemote Controller ProcessingTurning On & First Time Setup ContentsUsing the Listening Modes Introduction2 3 4 5 6 78 9J K L Front & Rear PanelsFront Panel Display Front & Rear Panels—ContinuedFront & Rear Panels—Continued Rear PanelInstalling the Batteries Remote ControllerUsing the Remote Controller NotesRECEIVER/TAPE Mode Remote Controller—ContinuedAbout the Remote Controller Modes ASTANDBY button Remote Controller—ContinuedRemote Controller-Continued DVD ModeRemote Controller—Continued CD, MD & CDR ModesRemote Controller—Continued HDD ModeAbout Speakers Connecting Your SpeakersSpeaker Connection Precautions Connecting Your Speakers—ContinuedHow Many Speakers? Attaching the Speaker LabelsConnecting a Powered Subwoofer Connecting Speaker Set AConnecting Speaker Set B Connecting Your Speakers—ContinuedConnecting the Indoor FM Antenna Connecting AntennaConnecting the AM Loop Antenna Connecting an Outdoor FM Antenna Connecting Antenna—ContinuedConnecting an Outdoor AM Antenna NotesAbout AV Connections Connecting Your ComponentsOptical Digital Jacks AV Connection Color CodingWhich Connections Should I Use? Connecting Your Components—ContinuedVideo Connection Formats Audio Connection FormatsHint Connecting a TV or ProjectorConnecting Your Components—Continued Connecting Your Components—Continued Connecting a DVD playerConnecting Your Components—Continued Connecting a VCR or DVD Recorder for PlaybackVCR, DVD recorder or the otherConnecting Your Components—Continued Connecting a VCR or DVD Recorder for RecordingWith connection Connecting Your Components—ContinuedConnecting Your Components—Continued Connecting a CD Player or TurntableCD Player or Turntable with Built-inPhono Preamp StepCassette recorder, CDR, etc Connecting Another Component’s Power CordConnecting Your Components—Continued Connecting the Power Cord Connecting -capableOnkyo ComponentsConnecting Your Components—Continued NotesTurning On the AV Receiver Turning On & StandbySmooth Operation in a Few Easy Steps Assigning Digital Inputs to Sources First Time SetupChanging the Input Display TUNER Digital inputs cannot be assigned toSpeaker Conﬁguration First Time Setup—ContinuedYes: Select if a subwoofer is con nectedproperly, press the remote controller’s TEST First Time Setup—ContinuedNone NotesPlaying Your AV Components Basic AV Receiver OperationPlaying Your AV Components—Continued Using the Multichannel DVD InputDisplaying Source Information Interpreting Surround Channel InformationListening to the Radio Tuning into AM/FM Radio StationsListening to AM/FM Stations Displaying AM/FM Radio InformationListening to the Radio—Continued Connecting the XM AntennaListening to XM Satellite Radio Signing Up for XM Satellite Radioindicator Selecting XM Radio ChannelsListening to the Radio—Continued Channels cannot be selected while theSelecting XM Channels from the Front Panel Displaying XM Radio InformationListening to the Radio—Continued XM Radio Messages Positioning the XM AntennaSETUP button Listening to the Radio—ContinuedSelecting Presets Presetting AM/FM Stations & XM ChannelsDeleting Presets the preset number ﬂashesAdjusting the Bass & Treble Setting the Display BrightnessCommon Functions Muting the AV ReceiverAdjusting Speaker Levels Using the Sleep TimerUsing Headphones Common Functions—ContinuedSelecting with the Remote Controller Using the Listening ModesSelecting the Listening Modes Selecting on the AV receiverUsing the Listening Modes—Continued Using the Listening Modes—Continued About the Listening ModesUsing the Listening Modes—Continued Onkyo Original DSP ModesMono Movie OrchestraUsing the Late Night Function Dolby Digital only Using the CinemaFILTERUsing the Audio Adjust Settings Using the Listening Modes—ContinuedPL II & PL IIx Music Mode Settings Input Channel SettingsDTS Neo:6 Music Mode Setting Dolby Digital EX Input Signal SettingRecording the Input Source RecordingRecording from Different Sources 2.Prepare the VCR for recordingAdvanced Speaker Settings Advanced SetupCrossover Frequency Double BassSpeaker Distance Advanced Setup—ContinuedSpeaker Levels NotesAdvanced Setup—Continued Digital Signal Formatsbuttons to adjust the speaker 6Press the SETUP buttonNotes Entering Remote Control CodesControlling Other Components Controlling Other Components—Continued Resetting the Remote ControllerResetting the REMOTE MODE Buttons Controlling a TV Notes Learning Commands from Other Remote ControllersControlling Other Components—Continued Making Macros Using MacrosRunning Macros Deleting MacrosAudio TroubleshootingPower Tuner Troubleshooting—ContinuedVideo Recording Remote ControllerOthers Troubleshooting—ContinuedAmpliﬁer Section SpeciﬁcationVideo Section Tuner SectionMemo ONKYO EUROPE ELECTRONICS GmbH ONKYO U.S.A. CORPORATIONONKYO EUROPE UK Office ONKYO CHINA LIMITEDPage Page Page Page Page Page Page Page Page Page Page Page Page