Sharp PGLW3500, PG-LX3500, PGLX3500, PGLX3000, PG-LX3000, PG-LW3500 Set temporarily as follows

Page 14

Setting up the Projector Network Environment

5 Click “Internet Protocol Version 4 (TCP/IPv4)”, and click the “Properties” button.

1

2

6 Confirm or change an IP address for the setup computer.

1 Confirm and note the current IP address, Subnet mask and Default gateway.

Make sure to note the current IP address, Subnet mask and Default gateway as you will be required to reset them later.

2 Set temporarily as follows:

IP address: 192.168.150.3

Subnet mask: 255.255.255.0

Default gateway: (Do not input any values.)

Note

•The factory default settings for the projector are as follows:

DHCP Client: OFF

IP address: 192.168.150.2

Subnet mask: 255.255.255.0

Default gateway: 0.0.0.0

7 After setting, click the “OK” button, and then restart the computer.

After confirming or setting, proceed to “3. Setting up Network Connection for the Projector”.

-14

Image 14

Contents Setup Manual Connecting Pin Assignments Mini D-sub 15 pin female connectorConnecting Pin Assignments Basic format RS-232C Specifications and CommandsComputer control Communication conditions Commands ← O KDNR Dynamic Auto OK or ERR PAL RS-232C Speciﬁcations and Commands Operating the Projector Using the PJLinkTM Protocol SharpSetting up the Projector Network Environment Network settings on the computerConnecting the Projector to a Computer Setting an IP Address for the Computer Set temporarily as follows Setting up a Network Con- nection for the Projector DNS Controlling the Projector Using Internet Explorer Controlling the Projector via LANConfirming the Projector Controlling the ProjectorSetting and Adjusting Setting the SecurityMaking General Settings for Setting for Sending E-mail when an Error OccursMail Recipient Settings Resetting the Lamp Timer of the Projector via LAN Resetting the Lamp Timer of the Projector via LAN Troubleshooting Communication cannot be established with the projectorTroubleshooting ¥ After the initialization, carry out setting again