Sharp PG-LX3000 Setting up the Projector Network Environment, Network settings on the computer

Page 11

Setting up the Projector Network Environment

This section describes the basic procedure for using the projector via the network.

If the network is already constructed, the projector's network settings may need to be changed. Please consult your network administrator for assistance with these settings. You can make network settings both on the projector and on the computer. The following procedure is for making settings on the computer.

Network settings on the computer

1. Connecting the projector to a computer

Connect a LAN cable (Category 5, cross-over type) between the computer and projector.

LAN cable

(commercially available)

Page 12

2. Setting an IP address for the computer

Adjust the IP settings of the computer to enable one-to-one communications with the projector.

Temporarily change the computer's IP address.

Pages 13, 14

3. Setting up a network connection for the projector

Adjust the projector network settings to conform to your network.

Use Internet Explorer (version 6.0 or later) to make various projector settings.

Pages 15, 16

•Microsoft®, Windows®are registered trademarks of Microsoft Corporation in the United States and/or other countries.

•PJLink is a registered trademark or an application trademark in Japan, the United States, Canada, E.U., China and/or other countries/regions.

•All other company or product names are trademarks or registered trademarks of their respective companies.

-11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Setup Manual Mini D-sub 15 pin female connector Connecting Pin AssignmentsConnecting Pin Assignments Basic format RS-232C Specifications and CommandsComputer control Communication conditions ← O K CommandsDNR Dynamic Auto OK or ERR PAL RS-232C Specifications and Commands Sharp Operating the Projector Using the PJLinkTM ProtocolNetwork settings on the computer Setting up the Projector Network EnvironmentConnecting the Projector to a Computer Setting an IP Address for the Computer Set temporarily as follows Setting up a Network Con- nection for the Projector DNS Controlling the Projector via LAN Controlling the Projector Using Internet ExplorerControlling the Projector Confirming the ProjectorSetting the Security Setting and AdjustingSetting for Sending E-mail when an Error Occurs Making General Settings forMail Recipient Settings Resetting the Lamp Timer of the Projector via LAN Resetting the Lamp Timer of the Projector via LAN Communication cannot be established with the projector TroubleshootingTroubleshooting ¥ After the initialization, carry out setting again
Top Page Image Contents