Univex WFS709TP manual V1.0, May

WFS709TP ProSafe Smart Wireless Switch Hardware Installation Guide

Figure 2-1

•Use a Phillips or cross-head screwdriver to secure the chassis to the rack with two 12-24 screws (included) for each mounting bracket.

Note: Some racks require different screws which are not included. Make sure that you use the correct screws or fasteners for your rack system.

3.Ensure that there is adequate clearance around the chassis (Figure 2-2 on page 2-6).

•For proper air circulation, leave at least 10 cm (4 inches) clearance for the vents on the left and right of the chassis.

•Allow additional space in front and back of the chassis to access power cords, network cables, and indicator LEDs.

v1.0, May 2007