WFS709TP ProSafe Smart Wireless Switch Hardware Installation Guide
The port accepts an
Fans/Heat Exhaust 5
Three independent fans located on the side of the chassis promote proper air circulation for cooling the WFS709TP ProSafe Smart Wireless Switch.
During operation, the air vents on the left and right sides of the chassis must remain unobstructed by cables or mounting equipment. For proper air circulation, leave at least 10 cm (4 inches) of clearance on the left and right of the chassis.
Rack Mounting Brackets 6
Mounting brackets are attached to each side of the chassis.
Power Input Socket 7
The power input socket on the chassis rear panel accepts a power cord with a standard IEC320 connector. For proper safety and performance, the power cord must be rated to 10 A and must conform to grounded electrical standards in the country in which the switch operates.
Task Overview
As with any
NETGEAR Smart Wireless Components
Familiarize yourself with these three major components:
•WFS709TP Switch. This is an
Introduction |
v1.0, May 2007