Seiko Group FB 380 user manual Connecting the Interface Cable, Connecting to the Power Source

Page 12

Connecting the Interface Cable

Connect the parallel or USB interface cable as shown in the figure 2-8 below:

Caution

Make sure that the power switches of both printer and host computer are turned OFF before you connect the parallel interface cable.

Using the Parallel Interface and the USB Interface

The parallel interface

The USB interface

Parallel interface connector

USB interface connector

Parallel interface

cableUSB interface cable

Figure 2-8 Connecting the parallel interface cable and the USB interface cable

Connecting to the Power Source

Connecting the Power Cord

Plug the power cord (supplied) into the power inlet at the rear of the printer.

Check that the power switch (located on the left of the printer) is in the OFF position, then plug the power cord into the wall outlet.

Power switch

Power supply inlet

Power cord

Figure 2-9 Connecting the power cord to the printer

7

Image 12

Contents Seiko Precision Important Safety Instructions Table of Contents To enter the Setup Menu System and change the settings Epson Emulation Select Code Pages Features OverviewAutomatic Interface Switching High Resolution GraphicsHigh Quality, High Speed Printing User-Friendly Control PanelPreparation Unpacking Parts Identification Main parts of printer front viewInstallation Installing the Front Table Extension TrayInstalling and Replacing the Ribbon Cassette Make sure that the following Connecting the Interface Cable Using the Parallel Interface and the USB InterfaceConnecting to the Power Source Connecting the Power CordTurning the Power on and off Paper Thickness Adjustment Adjusting the gap adjust leverLoading Paper Position Copies ThicknessLoading Cut Sheets Loading cut sheetUsing Tractor Paper Loading Tractor PaperSetting tractor paper into the tractor Tearing off Tractor Paper Align the paper with the print start positionSetting Up Your Printer To Work With Software Printing from Your SoftwareLED Indicator Control PanelControl Panel Keys and LEDs OffTop of Form Adjustment Mode Basic Control Panel OperationsTear-off Adjustment Mode Using the Setup Menu SystemTo exit without saving, just turn the printer OFF To exit without saving, just turn off the printerTo enter the Setup Menu System and change the settings To exit the Setup Menu SystemPrinting the Current Setting Report To print the current settingsPage Seiko Precision FB-380 Options of the Setup Menu System Setup Menu SystemOptions Description FontRestoring Factory Printer Settings Using the Self Test FunctionsMaintenance Printing Test H pattern Slide Pattern Printing TestHex Dump Mode Print ModeMaintenance and Fault Finding Cleaning the CabinetAppendix a Cleaning the platen Intervals and Materials for CleaningError LED on the Control Panel Error Cause RemedySpecifications Appendix BGeneral Print HeadMechanism PaperPrint mode specifications Mode ×H inchesGraphic Print Specifications Signal Pin No Return Line Pin No Signal NameSignal Direction Parallel InterfaceCommand Code Summary USB InterfaceEpson Emulation Name Code Symbol Print ModeCharacter Set Graphics Mode Download CharacterBit-Image Input Data ControlSelect Code Pages Page Page Page Page Page Page Page Page