ENGLISH
REFERENCE
TROUBLESHOOTING
CONDITION |
| POSSIBLE CAUSES |
| POSSIBLE SOLUTIONS |
|
|
|
| |
No power. | • | The power cord is disconnected. | • Plug the power cord into the wall outlet | |
|
|
|
| securely. |
|
|
| ||
No sound. | • Power AC lead unplugged or power not | • Check AC lead is plugged in and power | ||
|
| switched ON. |
| switched on. |
|
|
| ||
| • Signal leads incorrectly connected. | • Check connections to amplifier. | ||
|
|
|
| |
| • Station not selected or weak signal with FM | • | ||
|
| MUTE |
|
|
|
|
|
| |
Noisy reception, hiss. | • | Weak signal. | • Check station tuning. Adjust or replace | |
|
|
|
| antenna. |
|
|
|
| |
Reception with whistling, buzzing noise. | • Interference from other computers, games | • | Check station tuning. Switch off or move the | |
|
| consoles. |
| source of electrical noise. |
|
|
|
| |
No RDS information. | • | Station signal too weak. | • Check station tuning. Adjust or replace | |
|
|
|
| antenna. |
|
|
|
| |
| • | Station not transmitting RDS data. | • Tune to an RDS station that supports program- | |
|
|
|
| service name (PS mode) and |
|
|
|
| mode). |
|
|
|
|
|
C 426 does not respond to remote control | • | Batteries are flat or incorrectly inserted. | • | Check batteries. |
commands. |
|
|
|
|
|
|
| ||
| • Infrared receiver (IR) window of the C 426 or IR | • Check IR windows and ensure clear | ||
|
| transmitter of the remote control is obstructed. |
| sight from remote control to C 426. |
|
|
|
| |
| • C 426 front panel is in very bright sunlight or | • | Reduce sunlight/room lighting. | |
|
| ambient light. |
|
|
|
|
|
|
|
RESTORING C 426 TO ITS FACTORY DEFAULT SETTINGS
1Press and hold both the front panel [MEMORY] and [PRESET/TUNE] buttons until all VFD icons are illuminated.
2Immediately press any front panel button; the C 426 will go to standby mode.
3Press the STANDBY button to power up C 426 from standby mode; the C 426 is restored to its factory default settings with all Presets cleared/erased.
12