NAD C426 owner manual TNR 1 Remote Control, Sleep Mode, Dimmer

IDENTIFICATION OF CONTROLS

TNR 1 REMOTE CONTROL

1

3

4

6

7

9

10

DISP

BLEND

2

5

8

11

1ON: Power up C 426 from standby mode.

2OFF: Switch C 426 to standby mode.

30-9 number buttons: Direct-entry of frequency channel or preset number.

4DISP: Show RDS PS, RDS PT, Preset name or station frequency as applicable.

5SLEEP: Set sleep mode timer.

6PRESET: Step up or down between stored radio presets.

7TUNE: Tune forward or backwards.

8FM/AM: Select AM or FM band.

9BLEND: Activate or deactivate BLEND feature.

10FM MUTE: Activate or deactivate FM MUTE FM STEREO mode.

11DIMMER: Reduce, turn off or restore VFD brightness.

ENGLISH

SLEEP MODE

The Sleep Mode timer will switch the C 426 to standby mode automatically after a preset number of minutes. Toggle TNR 1’s [SLEEP] key to select through the following Sleep mode timer settings – SLEEP 30, SLEEP 60, SLEEP 90 and OFF. Stop at the desired Sleep mode timer setting. A corresponding “SLEEP” icon will be illuminated in the VFD.

While at SLEEP time mode, pressing the TNR 1’s [SLEEP] button once will display the remaining minutes (i.e. “SLEEP _ _”; “_ _” is the number of minutes remaining) before the C 426 goes to standby mode.

To cancel the sleep mode, continue pressing the TNR 1’s [SLEEP] button until “OFF” displays on the VFD. Switching the C 426 to standby from either the TNR 1’s [OFF] button or the front panel Standby button will also cancel the sleep mode.

DIMMER

The VFD brightness can be adjusted in three ways. Toggle the [DIMMER] button to reduce, turn off or restore VFD brightness.

9