SYSTEM FUNCTIONS
Testing the System (to be conducted weekly)
| Ready To Arm |
| |
Users | Events | Test | Keypad |
Date Time | Reminders | Slide Show | WiFi Config |
|
|
| Back |
|
|
| |
Ready To Arm
Prod. Id. : DE Sw.
Rev.: 05.00
CRC Number: 0X****
Walk Test | Dialer Test | Reboot |
Back
3.Select the “Test” icon. The system displays the Test screen.
4.Select the “Walk Test”, “Dialer Test” or “Reboot” icon. If Walk Test is selected proceed to Step 5. If Dialer Test is selected proceed to Step 6. If Reboot is selected proceed to Step 7.
5.“Walk Test…” is displayed on the system status bar and the control sounds a single beep every 30 seconds. Fault each zone as described below.
6. If the dialer test is unsuccessful the system will display a Reporter Failure message. Contact your security service provider.
7. The system will reboot itself.
8. After the reboot sequence is completed, conduct a Walk Test to verify that all transmitters are operational in the system.
Walk Test
FAULT ZONES. Open each protected door and window in turn and listen for three beeps from the control, followed by the zone’s Voice Descriptor, if it is programmed. Identification of each faulted protection point should appear on the display. The display will clear when the door or window is closed.
Walk in front of any interior motion detectors (if used) and listen for three beeps and/or voice descriptors, if programmed. The identification of the detector should appear on the display when it is activated, and its voice descriptor will be announced (if programmed). The display will clear when no motion is detected. Note that if wireless motion detectors are used, in order to conserve battery life, there is a
To test all smoke detectors, follow the manufacturer's instructions. The identification of each detector should appear on the display when each is activated.
