Honeywell L5100 manual Testing the System to be conducted weekly, Test Modes, Entering Test Mode

SYSTEM FUNCTIONS

Testing the System (to be conducted weekly)

Test Modes

The Test icon provides access to the Walk Test, Dialer Test and Reboot functions. The Walk Test mode allows each protection point to be checked for proper operation. When the Walk Test mode is active, the control sounds a single beep every 30 seconds as a reminder that the system is in the Test mode. The Dialer Test performs a check of the system dialer. The Reboot feature allows you to reboot the system if required.

NOTE: An alarm message will not be sent to your alarm monitoring company during these tests.

Entering Test Mode

Disarm the system and close all protected windows, doors, etc. The “Ready” indicator should be lit.

Testing or Rebooting the System

Ready To Arm

				Tools
Arm Away	Arm Stay	Dashboard		Settings
Delay	10:18 AM June 8, 2010			Back
				5100-100-003-V0
	Ready To Arm
Program the system		1	2	3
Enter Code:		4	5	6
		7	8	9
	Cancel	Clear	0
				5000-100-009-V0

1.With the system in the disarmed state, select the “Tools” icon from the second page of the Home Screen. The system displays the Keypad screen.

2.Enter your 4-digit Master User Code. The system displays the Master User programming screen.

– 74 –