Honeywell L5100 manual User3

USER FUNCTIONS

User Access

123!@#

User3

Ready To Arm

6. If

desired you can enter a User Name.

Q

E

R

T

Y

U￿

I

O

P

Select the “Clear” key and then enter up to

W

10 characters of text.

Note:

Select the “ABC…” key to switch the

keyboard between upper/lower case or the

A

S

D

F

G

H

J

K

L

“123!@#” key to switch to numbers.

Clear

Z

X

C

V

B

N

M

1.

Once you are finished, select “Done”. The

system displays the Keypad screen.

abc...

Done

5000-100-081-V0

Ready To Arm

Name	03
Thomas
User Code	Z-wave Lock Control
****	Yes

Z-wave Unlocking Door

	Disarm
		Save
		5100-100-080-V0
	Ready To Arm
Master ****	Babysitter ****
Duress ****	Thomas ****
Edit	Add New	Delete
		5000-100-142-V0

8.Enter the 4-digit code for the new User followed by “Done”. The system returns to the Users Programming screen and the new User is displayed and along with ****

appears in the User Code field.

9.If a Z-Wave door lock is installed, select the “Z-wave Lock Control” key to enable the User. The system toggles between “No” and “Yes”. When “Yes” is selected, the User Code will be synchronized with all enrolled Z-wave door locks allowing the same User Code to be used at the door locks.

Note: The number of User Codes supported by

each door lock varies between manufacturers. To ensure compatibility, set the length of the Master User Code on the door lock to be greater than four digits.

10.If “Yes” is selected the system displays the “Z-wave Unlocking Door” key.

11.Select the “Z-wave Unlocking Door” key. The system toggles between “Disabled” and “Disarm”. When “Yes” is selected, entering a valid User Code with Z-wave Lock Control enabled at the door lock will disarm the system.

12.Once the User programming is complete select “Save”. The system returns to the Users screen and the new User is shown.

Note: **** appears to the right of User name after

avalid 4-digit User Code has been assigned to a specific User.

– 36 –