Sharp EL-W516, EL-W546, EL-W506 manual Calculation Ranges, Battery Replacement, Specifications

Page 8

Calculation Ranges

30

Within the ranges specified, this calculator is accurate to

±1 of the 10th digit of the mantissa. However, a calculation error increases in continuous calculations due to

accumulation of each calculation error. (This is the same for yx, xr, n!, ex, ln, Matrix/List calculations, etc., where

continuous calculations are performed internally.) Additionally, a calculation error will accumulate and become larger in the vicinity of inflection points and singular points of functions.

Calculation ranges

±1099 to ±9.999999999 1099 and 0.

If the absolute value of an entry or a fi nal or intermediate result of a calculation is less than 1099, the value is considered to be 0 in calculations and in the display.

Display of results using r

Calculation results may be displayed using rwhen all of the following conditions are met:

When intermediate and final calculation results are displayed in the following form:

±aPb ± cPd

⎯ ⎯

e f

• When each coeffi cient falls into the following ranges: 1 a < 100; 1 < b < 1,000; 0 c < 100;

1 d < 1,000; 1 e < 100; 1 f < 100

When the number of terms in the intermediate and final calculation results is one or two.

Note: The result of two fractional terms that include rwill be reduced to a common denominator.

BATTERY REPLACEMENT

Notes on Battery Replacement

Improper handling of batteries can cause electrolyte leakage or explosion. Be sure to observe the following handling rules:

Make sure the new battery is the correct type.

When installing, orient the battery properly as indicated in the calculator.

The battery is factory-installed before shipment, and may be exhausted before it reaches the service life stated in the specifi cations.

Notes on erasure of memory contents

When the battery is replaced, the memory contents are erased.

Replacement Procedure

1.Turn the power off by pressing @o.

2.Remove the two screws. (Fig. 1)

Fig. 1

3.Slide the battery cover slightly and lift it

 

to remove.

 

4.Remove the used battery by prying it

 

out with a ball-point pen or other similar

 

pointed device. (Fig. 2)

Fig. 2

5.Install one new battery. Make sure the

 

+” side is facing up.

 

6.Replace the cover and screws.

 

7.Press the RESET switch (on the back)

with the tip of a ball-point pen or similar object.

8.Adjust the display contrast. See “Adjusting the Display Contrast”.

Make sure that the display appears as shown below. If the display does not appear as shown, remove the battery, reinstall it, and check the display once again.

Automatic Power Off Function

This calculator will turn itself off to save battery power if no key is pressed for approximately 10 minutes.

SPECIFICATIONS

Calculation features:

Scientifi c calculations, complex

 

number calculations, equation solvers,

 

statistical calculations, etc.

Drill features:

Math Drill and Multiplication Table

Display:

96 32 dot matrix liquid crystal

 

display

Display of calculation results:

 

Mantissa: 10 digits

 

Exponent: 2 digits

Internal calculations:

Mantissas of up to 14 digits

Pending operations:

64 calculations 10 numeric values

 

(5 numeric values in CPLX mode, and

 

1 numeric value for Matrix/List data.)

Erasure can also occur if the calculator is defective or when it is repaired. Make a note of all important memory contents in case accidental erasure occurs.

When to Replace the Battery

If the display has poor contrast or nothing appears on the display when jis pressed in dim lighting, even after adjusting the display contrast, it is time to replace the battery.

Cautions

An exhausted battery left in the calculator may leak and

 

damage the calculator.

Fluid from a leaking battery accidentally entering an eye could

 

result in serious injury. Should this occur, wash with clean

 

water and immediately consult a doctor.

Should fl uid from a leaking battery come in contact with your

 

skin or clothes, immediately wash with clean water.

If the product is not to be used for some time, to avoid damage

 

to the unit from a leaking battery, remove it and store in a safe

 

place.

Power source:

Operating time: (varies according to use and other factors)

Operating temperature:

External dimensions:

Weight:

Accessories:

Built-in solar cells

1.5 V —… (DC): Backup battery

(Alkaline battery (LR44 or equivalent)

1)

Approx. 3,000 hours when continuously displaying 55555. at 25°C (77°F), using the alkaline battery only

0°C–40°C (32°F–104°F)

79.6mm (W) 161.5 mm (D)

15.5mm (H)

3-1/8” (W) 6-11/32” (D) 5/8” (H)

Approx. 102 g (0.23 lb) (including battery)

Battery 1 (installed), operation manual, calculation examples, and hard case

Do not leave an exhausted battery inside the product.

Keep batteries out of the reach of children.

Explosion risk may be caused by incorrect handling.

Do not throw batteries into a fire as they may explode.

FOR MORE INFORMATION

ABOUT SCIENTIFIC CALCULATORS

Visit our Web site.

http://sharp-world.com/calculator/

Image 8
Contents Display Before Using the CalculatorIntroduction SET UP Menu WriteView EditorLine Editor Editing the EquationArithmetic Operations Constant CalculationsFunctions Integral/Differential FunctionsOperations N-base Chain CalculationsFraction Calculations Calculations Using Engineering Prefixes Simulation Calculation AlgbSolver Function Statistical Calculations and VariablesUsing Matrices in Calculations Ranges of Math Drill QuestionsComplex Number Entry Entering and Storing MatricesErrors and Calculation Ranges Alert MessagesBattery Replacement SpecificationsCalculation Ranges For More Information About Scientific Calculators+&kzS` $twysH ilOVYZA1 MDqBecaWTxmMT Xijkl Zrgh/dn4 pxC NengNalgb Nsolver24 N→t, P, Q, R 22 Hud#28 b2-VLE, 3-VLE, QUAD, Cubic BMATRIXBLIST −10100 x 180⎯ ⋅+ BD − ADNur für Deutschland/For Germany only UmweltschutzProtection de l’environnement MiljöskyddNederlands