Sharp MX-2314N, MX-2614N, MX-3114N installation manual ǂǂǂ

(4)Copy/Printer color balance and density adjustment (Automatic adjustment)

When a printer option is installed, be sure to execute the above item.

1)Enter the SIM46-74 mode.

ǂǂǂ ǂǂ

2)Press [EXECUTE] key.

The high density process control is performed, and the copy color patch image (adjustment pattern) is printed out.

(A4/11" x 8.5" or A3/11" x 17" paper is automatically selected.)

ǂǂǂ ǂǂ

3)Set the color patch image (adjustment pattern) paper printed in procedure 2) on the document table.

Set the color patch image (adjustment pattern) printed in the procedure 2) on the document table. Place the color patch image so that the fine lines are on the left side. At that time, place 5 sheets of white paper on the printed color patch image (adjustment pattern).

4)Select [FACTORY] target, and press [EXECUTE] key.

When the color balance is customized by the manual color bal- ance adjustment (SIM 46-21) according to the user's request, and the color balance is registered with SIM63-7 as the service target, if the color balance is required to be adjusted, select the [SERVICE] target.

ǂǂǂ ǂǂ

The copy color balance adjustment is automatically executed and prints the color balance check patch image.

If there is any streak or unclear print on the printed check pat- tern, check the print engine for any problems.

Low	High
density	density

Y

M

C

Bk

A B C D E F G H I J K L M N O P Q

5)Press [EXECUTE] key.

The printer color patch image (adjustment pattern) is printed out. (A4/11" x 8.5" or A3/11" x 17" paper is automatically selected.)

ǂǂǂ ǂǂ

h

MX-3114N MX-2314N/2614N/3114N (MAIN UNIT) 2 – 13