Technicolor - Thomson DPL5000 manual Getting Started

Getting Started

Getting Started

Unpacking the Receiver

You should receive the following items:

Inserting Batteries into Remote Control

Install batteries as follows:

Protect your Components from
Overheating	EN

			+	-
ON/ECO		SUBWOOFER SOURCESURROUNDPRESET	+	-
		VOLUME
		PHONES
	One receiver unit		One pair of “AAA”
			batteries

TUNER

DVD 6CH

PR

ST MONO

RDS PTY

SURROUNDNIGHT

EQUALIZER LEVEL

SUBWOOFER

1.Remove the battery compartment door by applying thumb pressure on battery door and then lift the door out and off the cabinet.

2.Insert 2 “AAA” (R03) batteries into the battery compartment according to the + and - signs in the compartment and replace the compartment door.

3.To use the remote control, point it directly at your receiver.

Set up and Maintenance of the Receiver

Provide spaces for sufficient ventilation as indicated:

•Do not block ventilation holes in any component. Arrange the components so that air can circulate freely.

•Do not stack components directly on top of each other.

•Do not place the unit near other components that generate heat such as heating vents.

•Allow adequate ventilation when placing your components in a stand.

•Place an amplifier near the top shelf of the stand so heated air rising from it will not affect other components. If you have a satellite receiver, you should place it on the top shelf.

		one audio cable (two
One pig-tail	One external AM loop	wires) with red and
antenna wire	antenna	white RCA connectors;

SET UP		GUIDE
TUNER -	SAVE	TUNER +

	10 cm/4"
10 cm/	Front View	10 cm/
4"		4"

Using Headphones

To listen privately through your audio system, use the PHONES jack on the receiver. However, make sure you turn down the volume before you

	•	one instruction book;	TAPE CD	AUX 1	AUX 2
				(VCR)	(SAT CABLE)
Thomson	•	Thomson Warranty Card;
Warranty
Card	•	one Quick Connection Guide
			One Remote Control
			one Video cable

Unpacking The Speakers • 6 speaker wires including:

• one set of speakers include 1 set of left and right front speakers, 1 center speaker, 1 subwoofer and 1 set of left and right rear speakers.

1 X silver wire with	1 X silver wire with
green/black band for	red/black band for front
center speaker	right speaker

1 X silver wire with	1 X silver wire with
	purple/black band for
white/black band for
	subwoofer
front left speaker

1 X silver wire with	1 X silver wire with
blue/black band for rear	grey/black band for rear
left speaker	right speaker

		10 cm/4"
5 cm/
2"	Side View

•Do not connect to the AC power cords until all connections are completed.

•Do not use your set immediately after transferring it from a cold place to a warm place: there is risk of condensation.

•Do not expose your set to water and excessively high temperatures.

•After having disconnected your set, clean the case with a soft cloth, or with a slightly damp leather chamois. Never use strong solvents.

put on the headphones. Increase the volume to the desired level after headphones are in place.

Once headphones are connected, “HEADPHONE DOWN MIX 2 CHANNEL” will scroll on display. This feature automatically converts multi-channel speaker outputs to 2 channel stereo for your listening pleasure.

Hearing Comfort & Well-Being

•Do not play your headset at a high volume. Hearing experts advise against continuous extended play.

•If you experience a ringing in your ears, reduce volume or discontinue use.

2 3