Configure the Gateway | TANDBERG Gateway |
|
|
IP Configuration
To configure the IP settings on the gateway, open ‘IP’ as shown in the figure below.
Configuration
IP Address Assignment
DHCP: Dynamic Host Configuration Protocol can be selected when a DHCP server is present.
Static IP Address, Static IP Subnet Mask and Static IP Gateway are ignored because these parameters are assigned by the DHCP server.
Static: If Static assignment is used, the gateway’s
IP Ethernet Speed
Auto The gateway will automatically detect the speed/duplex on the LAN. 10Half The gateway will connect to the LAN using 10 Mbps/Half Duplex. 10Full The gateway will connect to the LAN using 10 Mbps/Full Duplex. 100Half The gateway will connect to the LAN using 100 Mbps/Half Duplex. 100Full The gateway will connect to the LAN using 100 Mbps/Full Duplex.
40