Runco CL-500 manual Installation, Remote Control, Projector, Connect the Power Cord

Page 12

Runco

2. Installation

Remote Control

Push and slide to open the cover. Install the two

AAAbatteries with the correct polarity, then close the cover.

Notes on Batteries

Make sure that the battery polarities are correct when installing the batteries.

Do not mix an old battery with a new one or different types of batteries.

If you will not use the remote control for a long time, remove the batteries to avoid damage from battery leakage.

Notes on Remote Control Operation

Make sure that there is nothing obstructing the infrared beam between the remote control and the IR receiver on the projector.

The useable range is between 3m (from the front of the projector) and 4m (from the rear of the projector) within 30 degree horizontal angle and 15 degree vertical angle.

Projector

Connect the Power Cord

Plug the supplied power cord into the AC inlet in the rear of this unit.

Turn on the main power switch in the rear of this unit (next to the AC inlet). The POWER LED will light up in orange. Press ON key on the remote control for ONE second to turn on the unit.

82. Installation

Image 12
Contents CL-500 Page Limited Warranty Effective Warranty Date Runco CL-500 Video Projector User’s Manual Page Features OverviewLocation Front / Upper SideRear / Bottom Side Controls and Functions Control PanelZoom Ring Focus RingConnector Panel Computer D-Sub 15-pin RGB Computer signal input12v Trigger mini jack Remote Control Component HD DTV Y/ PB/PR signal inputAnamorphic For PIP Picture in PictureInstallation Remote ControlConnect the Power Cord ProjectorAdjust the Lens Zoom/Focus ring Adjust the heightFor 16 x 9 Screens For 4 x 3 ScreensThrowDistanc61.00 eChart109.00 Connecting Connecting Video InputsVideo/ S-Video/ Component Interlaced Video Progressive Component DTV Y/PB/PR Rgbhv DTV RGBConnecting a Computer Turning on the Power Zoom/ FocusingBasic Operation Selecting Input SourceSetting Menu Selecting Aspect ratioSelecting Video Memory Turning off the Power PIP functionUsing the Menu Picture SettingMenu Display Setting Screens Environment Setting Install SettingAdditional Information Replace the Lamp Contact your Runco DealerTroubleshooting Problem Cause RemedySpecifications Dimensions PC Out Adapter Code FunctionPage RUMA-009550 rev