Runco CL-500 manual Basic Operation, Turning on the Power, Zoom/ Focusing, Selecting Input Source

Page 19

User’s Manual

4. Basic Operation

Turning on the Power

The Power LED lights orange when power is applied and the power switch is turned on.

Press and hold the ON key on the remote control for ONE second to turn on the unit. The POWER LED will blink orange during warm up period, then light solid green.

" Searching…." will be displayed on the screen before the projector identifies the input signal. This message will remain on the screen until a valid signal is detected.

If the horizontal frequency of the input signal exceeds the range of the projector (XGA), a " Not supportive timing " message will be displayed on the screen. This message will remain on screen until you change the input signal.

ON

OFF

VIDEO

S-VIDEO

COMPONENT

COMPONENT HD RGB HD

PC

Zoom/ Focusing

Adjust the projection image size you need with the zoom ring on the lens. To focus the image, rotate the focus ring on the lens.

 

Focus

 

Focus

Zoom out

Zoom

Zoom inin

Selecting Input Source

When this unit is turned on, it will search for the input source you selected last time.

You may select the input source directly on the remote control.

VIDEO

S-VIDEO

COMPONENT

COMPONENT HD RGB HD

PC

4. Basic Operation 15

Image 19
Contents CL-500 Page Limited Warranty Effective Warranty Date Runco CL-500 Video Projector User’s Manual Page Overview FeaturesFront / Upper Side LocationRear / Bottom Side Focus Ring Controls and FunctionsControl Panel Zoom RingComputer D-Sub 15-pin RGB Computer signal input Connector Panel12v Trigger mini jack PIP Picture in Picture Remote ControlComponent HD DTV Y/ PB/PR signal input Anamorphic ForProjector InstallationRemote Control Connect the Power CordAdjust the height Adjust the Lens Zoom/Focus ringFor 4 x 3 Screens For 16 x 9 ScreensThrowDistanc61.00 eChart109.00 Connecting Video Inputs ConnectingVideo/ S-Video/ Component Interlaced Video Rgbhv DTV RGB Progressive Component DTV Y/PB/PRConnecting a Computer Selecting Input Source Turning on the PowerZoom/ Focusing Basic OperationSelecting Aspect ratio Setting MenuSelecting Video Memory PIP function Turning off the PowerPicture Setting Using the MenuMenu Display Setting Screens Install Setting Environment SettingReplace the Lamp Contact your Runco Dealer Additional InformationProblem Cause Remedy TroubleshootingSpecifications Dimensions Code Function PC Out AdapterPage RUMA-009550 rev